Pioneer VSX-1025-K: Symptom Remedy

VSX-1020_SYXCN.book 111 ページ ２０１０年３月１２日　金曜日　午前９時１０分

Additional information 12

Symptom Remedy

English

Noise is output when

• This is not a malfunction of the receiver. The scan function of your player

scanning a DTS CD.

alters the digital information, making it unreadable, resulting in noise being

output. Lower the volume when scanning.

When playing a DTS format

• Make sure that the input signal type is set to DIGITAL (see Choosing the input

LD there is audible noise on

signal on page 61).

the soundtrack.

Deutsch

Can’t record audio. • You can only make a digital recording from a digital source, and an analog

recording from an analog source.

• For digital sources, make sure that what you’re recording isn’t copy protected.

• Check that the OUT jacks are properly connected to the recorders input jacks

(see Connecting other audio components on page 30).

Français

Subwoofer output is very low. • To route more signal to the subwoofer, set it to PLUS or set the front speakers

to SMALL (see Speaker Setting on page 102).

Everything seems to be set up

• The speakers may be out of phase. Check that the positive/negative speaker

correctly, but the playback

terminals on the receiver are matched with the corresponding terminals on the

sound is odd.

speakers (see Connecting the speakers on page 20).

The PHASE CONTROL

• If applicable, check that the lowpass filter switch on your subwoofer is off, or

Italiano

feature doesn’t seem to have

the lowpass cutoff is set to the highest frequency setting. If there is a PHASE

an audible effect.

setting on your subwoofer, set it to 0º (or depending on the subwoofer, the

setting where you think it has the best overall effect on the sound).

• Make sure the speaker distance setting is correct for all speakers (see Speaker

Distance on page 103).

Nederlands

Noise or hum can be heard

• Check that personal computers or other digital components connected to the

even when there is no sound

same power source are not causing interference.

being input.

Can’t select some Input

• Check the Input Skip settings in the Input Setup menu.

functions by the INPUT

• Check the HDMI Input assignment in the Input Setup menu then try OFF.

SELECTOR on the front panel

or the INPUT SELECT button

Español

on the remote control.

There seems to be a time lag

• See Automatically conducting optimum sound tuning (Auto MCACC) on

between the speakers and

page 39 to set up your system again using MCACC (this will automatically

the output of the subwoofer.

compensate for a delay in the subwoofer output).

The maximum volume

• Check that the Volume Limit is set to OFF (see Volume Setup on page 106).

available (shown in the front

• The channel level setting may be over 0dB.

panel display) is lower than

the +12dB maximum.

111

En