Pioneer VSX-1025-K: Multi operation and System off

Controlling the rest of your system 09

The buttons that can be programmed using

English

Multi operation and System off

Multi operation or System off are the same

buttons as those that can be programmed for

The Multi operation feature allows you to

other remote controls (see Programming

program a series of up to 5 commands for the

signals from other remote controls on page 78).

components in your system.

• Be sure to call up the preset codes of

Programming a Multi operation or a

Deutsch

devices or perform programming signals

shutdown sequence

for other remote controls before multi

operation memory programming

(page 78)

.

1 Press and hold

R.SETUP

, then press “3”

for three seconds.

The Multi operation feature makes it easy to

The LED flashes continuously.

perform the following operations by pressing

Français

just two buttons.

• To cancel the preset setup mode press

R.SETUP.

Press MULTI OPERATION and then the DVD

input function button to:

2 Press the input function button (or



1. Switch this receiver on.

SOURCE

button).

2. Switch this receiver’s input to DVD.

For Multi operations, press the input function

Italiano

3. Transmit a sequence of up to five

you wish to program (for example, if you want

programmed commands.

to start the sequence by switching on your

3

DVD player, press DVD).

Similar to Multi operations, System off allows

you to use two buttons to stop and switch off a

For System off, press the  SOURCE button.

series of components in your system at the

The LED blinks twice and flashes

1

Nederlands

same time.

Only one System off operation

continuously.

sequence may be programmed.

3 If necessary, press the input function

Press

MULTI OPERATION

and then



SOURCE

button for the component whose command

to:

you want to input.

1. Transmit a sequence of up to five

This is only necessary if the command is for a

programmed commands.

new component (input function).

Español

2. Switch off all Pioneer devices including the

4 Select the button for the command you

receiver (except DVD recorders and VCRs).

want to input.

For greater convenience, program this receiver

The LED blinks once and flashes continuously.

to perform power on/off and playback

2

• You don’t need to program the receiver to

operations on non-Pioneer devices as well.

switch on or off. This is done automatically.

(The signals for Pioneer devices described

above are not contingent on programming for

non-Pioneer devices.)

81

En

VSX-1020_SYXCN.book 81 ページ ２０１０年３月１２日　金曜日　午前９時１０分

1 • Before Multi operation and System off will work correctly, you must setup the remote to work with your TV and other

components (see Operating multiple receivers on page 77 for more on this).

• Some units may take some time to power up, in which case multiple operations may not be possible.

• Power on and off commands only work with components that have a standby mode.

2 Some remote controllers for other manufacturers' devices use the same signals for switching the power on and off.

In some cases, even if this receiver is programmed to perform these commands, power to the non-Pioneer devices

may not be switched on and off correctly. Program the receiver to perform these commands if the non-Pioneer device

uses separate signals for power on/off.

3 With Multi operation, the HDMI and TV CTRL settings cannot be made, but the iPod USB settings can. For other

settable input functions, see Setting the remote to control other components on page 77.