Pioneer VSX-1025-K: Symptom Remedy Important information regarding the HDMI connection

VSX-1020_SYXCN.book 117 ページ ２０１０年３月１２日　金曜日　午前９時１０分

Additional information 12

Symptom Remedy

English

When Control with HDMI is

• Even when Control with HDMI is set to ON, for Digital In assignment of

set to ON, the HDMI Input

HDMI 1 is not canceled, so in this case use the HDMI IN 1 input.

assignment at Input Setup is

canceled.

Synchronized operation not

• Check the HDMI connections.

Deutsch

possible using Control with

• The cable may be damaged.

HDMI function.

• Select ON for the Control with HDMI setting (see HDMI Setup on page 64).

• Select ALL for the Control Mode

setting (see HDMI Setup on page 64).

• Turn the TV’s power on before turning on this receiver’s power.

• Set the TV side Control with HDMI setting to on (see TV’s operating

instructions).

Français

Important information regarding the HDMI connection

There are cases where you may not be able to

Configuration B

route HDMI signals through this receiver (this

Connect your HDMI-equipped component

depends on the HDMI-equipped component

directly to the display using an HDMI cable.

you are connecting–check with the

Then use the most convenient connection

Italiano

manufacturer for HDMI compatibility

(digital is recommended) for sending audio to

information).

the receiver. See the operating instructions for

If you aren’t receiving HDMI signals properly

more on audio connections. Set the display

through this receiver (from your component),

volume to minimum when using this

please try one of the following configurations

configuration.

Nederlands

when connecting up.

Note

Configuration A

Use component video cables to connect the

• If your display only has one HDMI

video output of your HDMI-equipped

terminal, you can only receive HDMI video

component to the receiver’s component video

from the connected component.

Español

input. The receiver can then convert the analog

• Depending on the component, audio

component video signal to a digital HDMI

output may be limited to the number of

signal for transmission to the display. For this

channels available from the connected

configuration, use the most convenient

display unit (for example audio output is

connection (digital is recommended) for

reduced to 2 channels for a monitor with

sending audio to the receiver. See the

stereo audio limitations).

operating instructions for more on audio

• If you want to switch the input function,

connections.

you’ll have to switch functions on both the

receiver and your display unit.

Note

• Since the sound is muted on the display

• The picture quality will change slightly

when using the HDMI connection, you

during conversion.

must adjust the volume on the display

every time you switch input functions.

117

En