Pioneer VSX-1025-K: Basic Setup04

Basic Setup04

®

The Full Auto MCACC display appears once the

THX

2

microphone is connected.

THX is a trademark of THX Ltd., which may be

registered in some jurisdictions. All rights

reserved.

1 Switch on the receiver and your TV.

2 Connect the microphone to the

MCACC

SETUP MIC

jack on the front panel.

Make sure there are no obstacles between the

speakers and the microphone.

3

3 Select the parameters you want to set.

If the speakers are connected using any setup

other than the Front height setup, be sure to

set Speaker System before the Auto MCACC

Setup. See Speaker system setting on

page 101.

4

• Speaker System

– Select your speaker

system setting.

• EQ Type – This determines how the

frequency balance is adjusted.

• MCACC – The six MCACC presets are used

for storing surround sound settings for

different listening positions. Simply choose

an unused preset for now (you can rename

it later in Data Management on page 98).

• THX Speaker – Select YES if you are using

If you have a tripod, use it to place the

THX speakers (set all speakers to SMALL),

microphone so that it’s about ear level at your

otherwise leave it set to NO.

normal listening position. If you do not have a

tripod, use some other object to install the

1

microphone.

40

En

1 Install the microphone on a stable floor. Placing the microphone on any of the following surfaces may make accurate

measurement impossible:

• Sofas or other soft surfaces.

• High places such as tabletops and sofa tops.

2 If you leave the GUI screen for over five minutes, the screen saver will appear.

3 • When data measurement is taken, the reverb characteristics data (both before- and after-calibration) that this

receiver had been storing will be overwritten. If you want to save the reverb characteristics data before measuring,

connect a USB memory device to this receiver and transfer the data.

• When measurement is taken of reverb characteristics data other than SYMMETRY, the data are not measured after

the correction. If you will need to measure after correcting data, take the measurement using the EQ Professional

menu in the Manual MCACC setup (page 93).

4 If you are planning on bi-amping your front speakers, or setting up a separate speaker system in another room, read

through Speaker system setting on page 101 and make sure to connect your speakers as necessary before continuing

to step 4.

VSX-1020_SYXCN.book 40 ページ ２０１０年３月１２日　金曜日　午前９時１０分