Zanussi ZBB 7297: MAINTENANCE

MAINTENANCE: Zanussi ZBB 7297

MAINTENANCE

Unplug the appliance before carrying out

any maintenance operation.

Periods of non-operation

When the appliance is not in use for long periods,

Warning

take the following precautions:

This appliance contains hydrocarbons in its cooling

remove the plug from the wall socket;

unit; maintenance and recharging must therefore

remove all food;

only be carried out by authorized technicians.

defrost and clean the interior and all accessories;

Periodic cleaning

leave the door ajar to allow air to circulate to prevent

Clean the inside with warm water and bicarbonate of

unpleasant smells.

soda.

Rinse and dry thoroughly.

Clean the condenser (black grill) and the

compressor at the back of the appliance with a

brush or a vacuum cleaner. This operation will

improve the performance of the appliance and save

electricity consumption.

Interior light

The light bulb inside the refrigerator compartment

can be reached as follows:

- unscrew the light cover securing screw.

- unhook the moving part as shown in the figure.

If the light does not come on when the door

is open, check that it is screwed into place

properly. If it still does not light up, change

the bulb.

The rating is shown on the light bulb

cover.

D411

Defrosting

Frost is automatically eliminated from the evaporator

of the refrigerator compartment every time the motor

compressor stops, during normal use. The defrost

water drains out through a trough into a special

container at the back of the appliance, over the

motor compressor, where it evaporates.

It is important to periodically clean the defrost

water drain hole in the middle of the refrigerator

compartment channel to prevent the water

overflowing and dripping onto the food inside.

Use the special cleaner provided, which you will

find already inserted into the drain hole.

The freezer compartment, however, will become

progressively covered with frost. This should be

removed with the special plastic scraper provided,

D037

whenever the thickness of the frost exceeds 4 mm.

During this operation it is not necessary to switch off

the power supply or to remove the foodstuffs.

22