Zanussi FLS 602: Something Not Working

Something Not Working

Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out

an engineer. Before contacting your Local service Force Centre, please carry out the checks listed below.

ENGLISH

Symptom Possible causes

■ Check that the door is firmly closed.

■ Check that the machine is plugged in and that there is power at the

socket.

The machine does not start up:

■ Check that the main fuse has not blown.

■ Check that the programme selector dial is positioned correctly and pulled

out.

■ Check that the water tap is open.

■ Check that water is coming out of the tap.

The machine does not fill:

■ Check that the inlet hose is not squashed or kinked.

■ Check that the filter in the inlet hose is not blocked.

■ Check that the door is closed.

The machine fills then empties

■ The end of the drain hose is too low. Refer to relevant paragraph in

immediately:

“water drainage” section.

■ Check that the drain hose is not squashed or kinked.

The machine does not empty and/or

■ The drain filter is blocked. Clean it.

does not spin:

■ The Rinse Hold option has been selected.

■ Too much detergent or unsuitable detergent (creates too much foam) has

been used.

■ Check whether there are any leaks from one of the inlet hose fittings. It

There is water on the floor:

is not always easy to see this as the water runs down the hose; check to

see if it is damp.

■ Check that the drain hose is not damaged.

■ Check that the drain filter has been refitted correctly after cleaning.

■ Too little detergent or unsuitable detergent has been used.

Unsatisfactory washing results:

■ Stubborn stains have not been treated prior to washing.

■ The correct temperature or programme was not selected.

If after all these checks, the problem persists, contact

Mod.

..........

Ser.

your local Service Force Centre, quoting the model and

serial number. This information can be found on the

rating plate (see picture).

Please note that it will be necessary to provide proof of

purchase for any in-guarantee service calls. In-guarantee

customers should ensure that the above checks have

Mod. ..........

Prod. No. ...........

been made as the engineer will make a charge if the

Ser. No. .........

P0042

fault is not a mechanical or electrical breakdown.

15