Asus V2-PH1: Removing the bay covers and reinstalling the front panel assembly and side cover

4.

For SATA HDDFor SATA HDD

For SATA HDDFor SATA HDD

For SATA HDD: Connect the

SATASATA

SATASATA

SATA

IDEIDE

IDEIDE

IDE

English

SATA signal and power plugs to

the connectors at the back of

the drive.

For IDE HDDFor IDE HDD

For IDE HDDFor IDE HDD

For IDE HDD: Connect the IDE

and power plugs to the connectors

at the back of the drive.

Removing the bay covers and reinstalling

the front panel assembly and side cover

If you installed an optical and/or floppy disk drive, remove the bay cover(s)

on the front panel assembly before reinstalling it to the chassis. To do this:

1. Locate the bay cover locks.

2. Press the locks outward to

release the bay cover.

3. Push the bay cover inward, then

set it aside.

4. Follow the same instructions to

remove the 3.5” drive bay cover.

To reinstall the front panel assembly and side cover:

1. Insert the front panel assembly hinge-like tabs to the holes on the

right side of the chassis.

2. Swing the front panel assembly to the left, then insert the hooks to

the chassis until the front panel assembly fits in place.

3. Insert the six side cover hooks into the chassis tab holes .

4. Push the side cover to the direction of the front panel until it fits in place.

5. Secure the cover with two screws you removed earlier.

1

11

11

22

22

2

55

55

5

Air ductAir duct

Air ductAir duct

Air duct

22

22

2

11

11

1

44

44

4

55

55

5

11

11

1

22

22

2

33

33

3

22

22

2

Chassis tab holesChassis tab holes

Chassis tab holesChassis tab holes

Chassis tab holes

1010

1010

10

Quick installation guideQuick installation guide

Quick installation guideQuick installation guide

Quick installation guide