Pioneer X-CM56: Chapter 1: Before you start What’s in the box Loading the batteries in the remote control

Before you start 01

Chapter 1:

English

Before you start

• Do not heat batteries, disassemble them, or throw them

into flames or water.

What’s in the box

Français Español

• Batteries may have different voltages, even if they are

Please confirm that the following accessories are in the box

the same size and shape. Do not use different types of

when you open it.

batteries together.

• Remote Control

• To prevent leakage of battery fluid, remove the

• AAA batteries (R03) x 2

batteries if you do not plan to use the remote control for

• Power cord

a long period of time (1 month or more). If the fluid

• Speaker wire x 2

should leak, wipe it carefully off the inside of the case,

then insert new batteries. If a battery should leak and

• AM antenna cable*1

the fluid should get on your skin, flush it off with large

• FM wire antenna*1

quantities of water.

• DAB/FM wire antenna*2

• When disposing of used batteries, please comply with

• Non-skid pads x 12

governmental regulations or environmental public

• Warranty card*3

institution’s rules that apply in your country/area.

• Operating instructions (this document)

*1 X-CM56 only

WARNING

*2 X-CM56D only

• Do not use or store batteries in direct sunlight or other

*3 European models only

excessively hot place, such as inside a car or near a

heater. This can cause batteries to leak, overheat,

explode or catch fire. It can also reduce the life or

performance of batteries.

Loading the batteries in the remote

control

Using the remote control

The remote has a range of about 7 m at an angle of about

1 Open the rear lid and load the batteries as

30º from the remote sensor.

illustrated below.

2 Close the rear lid.

Keep in mind the following when using the remote control:

• Make sure that there are no obstacles between the

remote and the remote sensor on the unit.

• Remote operation may become unreliable if strong

sunlight or fluorescent light is shining on the unit’s

remote sensor.

CAUTION

• Remote controllers for different devices can interfere

• Do not use any batteries other than the ones specified.

with each other. Avoid using remotes for other

Also, do not use a new battery together with an old one.

equipment located close to this unit.

• When inserting the batteries, make sure not to damage

• Replace the batteries when you notice a fall off in the

the springs on the battery’s - terminals. This can

operating range of the remote.

cause batteries to leak or over heat.

• When loading the batteries into the remote control, set

them in the proper direction, as indicated by the polarity

marks (+ and -).

5

En

SN29402593_X-CM56&56D_En.book 5 ページ ２０１６年５月２７日　金曜日　午後３時４７分