Kenwood KRC-594: Installation

Installation: Kenwood KRC-594

Installation

Removing the hard rubber frame

Removing the Unit

1 Engage the catch pins on the removal tool and remove the

1 Refer to the section <Removing the hard rubber frame> and

two locks on the upper level.

then remove the hard rubber frame.

English

Upper the frame and pull it forward as shown in the figure.

2 Remove the screw (M4×8) on the back panel.

3 Insert the two removal tools deeply into the slots on each

side, as shown.

Lock

Screw (M4X8)

Accessory2 Removal tool

Catch

(commercially

available)

Accessory2

Removal tool

2 When the upper level is removed, remove the lower two

locations.

4 Lower the removal tool

toward the bottom, and

pull out the unit halfway

while pressing towards the

inside.

Be careful to avoid injury from the catch pins on the removal tool.

5 Pull the unit all the way out

with your hands, being

careful not to drop it.

The frame can be removed from the bottom side in the same manner.

— 30

— 30

Оглавление