Kenwood KRC-594: Installation

Installation: Kenwood KRC-594

Installation

Installation

3 Tighten the screw (ø2.6 × 12 mm) (Accessory 4) in the hole

shown on the diagram.

Firewall or metal support

Accessory4

Screw (M4X8)

(commercially

available)

Bend the tabs of the

4 Tighten the screw (ø2 × 4 mm) (Accessory 5) in the hole

mounting sleeve

shown on the diagram.

with a screwdriver or

Self-tapping

Metal mounting

similar utensil and

screw

strap

attach it in place.

(commercially

(commercially

available)

available)

Make sure that the unit is installed securely in place. If the unit is

Accessory5

unstable, it may malfunction (eg, the sound may skip).

5 Tighten the screws (ø2 × 6 mm) (Accessory 6) in the holes

shown on the diagram.

Screwing the Faceplate on the Unit

If you want to fasten the faceplate to the main unit so that it

does not fall off.

1 Refer to the section <Removing the hard rubber frame> and

then remove the hard rubber frame.

Accessory6

2 Drop open the faceplate by pressing the Release button.

Never insert the screws in any other screw hole than the one specified.

If you screw them in another hole, it will contact and may cause

damage to the mechanical parts inside the unit.

— 29

Оглавление