Kenwood CM470 series: инструкция

Kenwood Limited, New Lane, Havant, Hampshire PO9 2NH, UK

www.kenwood.co.uk

56088/3

CM470 series

CM480 series

English 2 - 4

Nederlands 5 - 8

Français 9 - 12

Deutsch 13 - 16

Italiano 17 - 20

Português 21 - 24

Español 25 - 28

Dansk 29 - 32

Svenska 33 - 35

Norsk 36 - 38

Suomi 39 - 42

Türkçe 43 - 46

Ïesky 47 - 50

Magyar 51 - 54

Polski 55 - 58

Русский 59 - 63

Ekkgmij 64 - 68

´¸∂w

71 - 69

UNFOLD





































before using for the first time

safety

1 Remove all packaging.

● Watch out for steam, never lift the

2 Wash the parts: see ‘care and

tank lid during the brewing cycle.

cleaning’.

● CM470 series only: never touch

3 Push excess cord inside the back of

the hotplate.

the machine.

● Always lift the lid using the lid

4 Run two lots of water through the

opening lip.

machine (without coffee) to clean it

● Don’t touch hot parts including the

out. Fill the tank to the top cup mark

cup storage area.

when you do this. See ‘to make

● Keep children away from the

coffee’.

machine. And never let the cord

hang down where a child could

key

grab it. Push excess cord inside the

 water filter

back of the machine.

 water filter holder

● Never use a damaged machine. Get

 removable water tank

it checked or repaired: see ‘service’.

 lid

● Never put the machine in water or

 compartment for excess cord

let the cord or plug get wet - you

 hotplate (model CM470 series only)

could get an electric shock.

 anti drip activating device

● Unplug:

 program button

●●

before filling with water

 clock button

●●

before cleaning

 on/off button with indicator light

●●

after use.

 glass carafe and lid

● Never leave the machine on

(model CM470 series only)

unattended.

 thermal carafe and lid

● Don’t let the cord touch hot parts.

(model CM480 series only)

● Don’t let infirm people use the

 measuring spoon

machine without supervision.

 filter holder

● Don’t let children play with this

 permanent coffee filter (or use a

machine.

paper filter instead)

● Only use the machine for its

 lid opening lip

intended domestic use.

 aroma control

● Always make sure there is water in

 cup storage area

the tank before switching on.

● This coffee maker is only suitable for

to make coffee

use with the type of carafe supplied.

1 Lift the lid.

2 Lift out the water tank from the

before plugging in

coffee maker.

Make sure your electricity supply is

3 Separate the water filter holder by

the same as the one shown on the

pulling the unit apart and place the

underside of your machine.

water filter inside. Fit the unit back

●

This machine complies with

together.

European Economic Community

4 Turn the handle on the water filter

Directive 89/336/EEC.

holder and align the arrow on the

base with the letter for the current

corresponding month eg F for

February.

2

5 Lower the water filter holder into the

To stop the brewing process at any

water tank and fit into position in the

time, press the on/off button. The

recess.

back light of the display will come on

6 Fill the tank with the desired amount

for one minute and then go off

of water. The water must be

automatically.

between the top and bottom cup

14Don’t remove the carafe until

marks. Do not fill above the MAX

brewing has finished.

level. (Alternatively fill the water tank

CM470 series

when fitted inside the coffee maker

● The hot plate will keep your coffee

but take care not to cause spillage.)

hot, but the sooner you drink it, the

● Use cold water. We recommend

better it will taste.

using filtered water from a Kenwood

● Your coffee maker will keep the

Water Filter as it reduces limescale.

coffee warm and then automatically

Never use warm or fizzy water.

switch off after 2 hours. To manually

7 Replace the water tank back into the

switch off earlier, press the on/off

coffee maker.

button.

8 Ensure the filter holder is in position

CM480 series

in the coffee maker.

● To pour coffee after brewing has

9 Fit either the permanent filter

finished, unscrew the lid 180° so

supplied or a paper filter into the

that the tab on the lid is in line with

filter holder. Add the coffee, use the

the pouring spout. Once the desired

spoon provided (approximately 1

amount of coffee has been poured,

level spoon per cup or to taste).

screw the lid back on to best retain

10Close the lid and adjust the aroma

the coffee temperature.

control as required. Turn the control

● As soon as all the coffee has

to the left for stronger coffee and to

brewed, switch off and unplug the

the right for weaker coffee.

machine.

11 CM470 series

● If you haven’t used the machine for

● Put the carafe on the hotplate.

a while, run one lot of water through

CM480 series

it (without coffee) to clean it out. Fill

To achieve the best performance,

the water tank to the top cup mark

rinse the thermal carafe with hot

when you do this.

water immediately before switching

● Never put the carafe in the

on the coffee maker.

microwave.

● Screw the lid onto the thermal

carafe. For brewing, the lid should

to set the clock

be fully closed with the tab on the

lid in line with the carafe handle. Put

1 Plug in the coffee maker, the

the carafe on the base.

backlight will come on and the

12 Plug into the power supply and

display will flash.

press the on/off button.

2 Select the correct time of day by

13Press the on/off button twice to start

pressing the clock button once and

brewing immediately. The on/off

the time will advance by 1 minute.

button will glow and the coffee

Press and hold down the button and

maker will start to operate. The back

the time will advance in 15 minute

light of the display will come on and

intervals.

automatically switch off after 10

● If required, press the program

minutes.

button once to change between the

12 and 24 hour clock.

3

3 To set the clock press the on/off

carafe, lid, permanent filter,

button or wait 1 minute for it to

filter holder, water filter

automatically set.

holder

● To re-adjust the clock at any time,

●

Wash, then dry.

press and hold the clock button for

body

5 seconds and adjust the clock as

●

Wipe with a damp cloth, then dry.

above.

Don’t use abrasives - they’ll scratch

Note – the backlight of the display

the plastic and metal surfaces.

will automatically turn off after 1

minute.

descaling

With use, the display will indicate

to program automatic brew

when the coffee maker requires

1 Set the clock to the correct time (see

descaling. A series of solid lines will

‘to set the clock’).

gradually appear and when 4 appear

2 Press the program button, the clock

in the display and flash , the

symbol and the display will flash.

coffee maker has completed 100

3 Press the clock button until the

cycles or more and requires

desired brewing time is displayed

descaling (see ‘to descale’).

(follow procedure in ‘to set the

clock’).

important

4 Press the on/off button to confirm

When descaling always remove the

the automatic time selected. (The

water filter and water filter holder

display panel and the on/off indicator

first.

light will flash).

5 Press the program button to return

to descale

to the current time of day (the on/off

1 Buy a suitable descaler.

button will continue to flash). The

2 Descale the machine.

brewing cycle will begin once the set

3 After descaling, run several lots of

time is reached and the on/off

water through the machine to clean

button will stop flashing.

it out. Fill the tank to the top cup

●

If you want to check the automatic

mark when you do this.

time selected, press the program

4 Wash the parts.

button.

5 To reset the descale counter to zero,

●

To override the automatic brewing

press the clock and program button

operation press the on/off button

at the same time for 2 seconds.

and the coffee maker will start

immediately. Press the button again

service

to switch off.

●

If the cord is damaged it must, for

safety reasons, be replaced by

care & cleaning

Kenwood or an authorised Kenwood

●

Always switch off, unplug and allow

repairer.

to cool before cleaning.

If you need help with:

●

Never put the machine in water or let

●

using your machine or

the cord or plug get wet.

●

servicing, spare parts or repairs

●

Don’t wash parts in the dishwasher.

Contact the shop where you bought

water filter

your machine.

●

Change and discard the water filter

after 70 brewing operations or within

a calender month whichever is

sooner.

4