Indesit WISE 107 X: Personalisations

Personalisations

Setting the spin cycle

FUNCTION buttons

If, when the appliance is switched on, the KNOB is positioned on

GB

a programme with a spin cycle, a fixed

appears. Press button

and the maximum spin speed allowed for the programme set

will be displayed, and the

icon flashes. Press it again and the

values lower until they reach OFF, which indicates that the spin

cycle has been excluded (press it again to go back to the

maximum value); stop on the desired speed, after approximately

2 seconds the setting is accepted: the symbol

remains fixed.

The spin cycle setting is enabled with all the programmes except

for 6 and the Draining cycle.

Setting the Delay Timer

Press the button and you will see the word OFF on the

display, while the relative symbol flashes.

Press the button again and "1h" appears, that is, a delay of one

hour (this can reach up to 24h); stop on the "desired" delay; after

approximately 2 seconds the setting is accepted, following which,

the time for the set programme appears on the display and the

symbol

remains on.

If you now press the START/RESET button, the set "delay"

appears; this decreases every hour until the start of the cycle. In

this phase, the "delay" can only be modified by decreasing it.

The Delay Timer regulation is enabled with all programmes.

Setting the temperature

If, when the appliance is switched on, the KNOB is positioned on a programme for which the temperature needs

to be regulated, a fixed

appears. Press button and the maximum temperature allowed for the programme set

will be displayed and the

icon flashes. Press it again and the temperature lowers until it reaches OFF, which

indicates a cold wash cycle (press it again to go back to the maximum value); stop on the desired value, after

approximately 2 seconds the setting is accepted: the symbol

remains fixed.

The temperature adjustment is enabled with all wash programmes.

Functions

To enable a function:

1. press the button corresponding to the desired function, according to the table below;

2. the function is enabled when the corresponding button is illuminated.

Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the

programme set.

If you set a function that is incompatible with another function you selected previously, only the last one selected

will be enabled.

Enabled with

Function Effect Comments

programmes:

Bleaching cycle

Please remember to pour the bleach into extra compartment 4

designed to

2, 3, 4,

(se

e page 8)

.

Stain

remove the

Rinse cycle.

This function is incompatible with the EASY IRON function.

removal

toughest stains.

Increases the

1, 2, 3, 4, 7,

Recommended when the appliance has a full load or with large

efficiency of the

8, 9, 11, 12,

quantities of detergent.

Extra Rinse

rinse.

Rinse cycle.

This option

When this function is set, programmes 4, 5, 6 will end, with the

reduces the

laundry left to soak (Anti-crease), and the relative button flashes:

amount of

- to conclude the cycle, press the START/RESET button or the

3, 4, 5, 6, 7, 8,

creasing on

EASY IRON button;

9, Rinse

ServiceTroubleshootingPrecautions CareProgrammes DetergentsInstallation Description

fabrics, making

- to run the draining cycle alone, set the knob to the relative

cycle.

them easier to

symbol and press the START/RESET button.

Easy iron

iron.

This function is incompatible with the STAIN REMOVAL function.

7