Indesit FA 757 J K.A IX: инструкция
Характеристики, спецификации
Инструкция к Духову Шкафу Indesit FA 757 J K.A IX
Operating Instructions
OVEN
Contents
GB
Warnings, 2
Installation, 3
GB
RU
KZ
Positioning
Electrical connections
English,1
11
Қазақша
,21
Data plate
Description of the appliance, 5
Overall view
Control panel
FA 757 J K.A IX
Start-up and use, 6
Starting the oven
Cooking modes, 7
Cooking modes
Practical cooking advice
Cooking advice table
The electronic cooking programmer, 8
Precautions and tips,9
General safety
Disposal
Respecting and conserving the environment
Maintenance and care, 10
Switching the appliance off
Cleaning the appliance
Cleaning the oven door
Replacing the light bulb
Assistance
Warnings
• WARNING: The appliance and its
GB
accessible parts become hot
during use.
• Care should be taken to avoid
touching heating elements.
• Children less than 8 years of age
shall be kept away unless
continuously supervised.
This appliance can be used by
children aged from 8 years and
above and persons with reduced
physical, sensory or mental
capabilities or lack of experience
and knowledge if they have been
given supervision or instruction
concerning use of the appliance
in a safe way and understand the
hazards involved. Children shall
not play with the appliance.
Cleaning and user maintenance
shall not be made by children
without supervision.
• Do not use harsh abrasive
cleaners or sharp metal scrapers
to clean the oven door glass since
they can scratch the surface,
which may result in shattering of
the glass.
• Never use steam cleaners or
pressure cleaners on the
appliance.
• WARNING: Ensure that the
appliance is switched off before
replacing the lamp to avoid the
possibility of electric shock.
•
! When you place the rack
inside, make sure that the
stop is directed upwards and
in the back of the cavity .
2
Installation
! Before placing your new appliance into operation
Ventilation
GB
please read these operating instructions carefully.
To ensure good ventilation, the back panel of the
They contain important information for safe use, for
cabinet must be removed. It is advisable to install the
installation and for care of the appliance.
oven so that it rests on two strips of wood, or on a
! Please keep these operating instructions for future
completely flat surface with an opening of at least 45 x
reference. Pass them on to possible new owners of
560 mm (
see diagrams
).
the appliance.
Positioning
! Keep packaging material out of the reach of
children. It can become a choking or suffocation
hazard. (
see Precautions and tips
).
! The appliance must be installed by a qualified
person in compliance with the instructions provided.
Incorrect installation may cause harm to persons,
Centring and fastening
animals or may damage property.
Secure the appliance to the cabinet by opening the
Fitting the appliance
oven door and putting 4 screws into the 4 holes of the
outer frame.
Use the appropriate cabinet to ensure that the
appliance functions properly.
• The panels adjacent to the oven must be made of
heat-resistant material.
• Cabinets with a veneer exterior must be assembled
with glues which can withstand temperatures of up
to 100°C.
• to install the oven under the counter (
see diagram
)
and in a kitchen unit, the cabinet must have the
following dimensions:
! All parts which ensure the safe operation of the
appliance must not be removable without the aid of a
tool.
547 mm. min.
45 mm.
23 mm.
560 mm.
575-585 mm.
595 mm.
567 mm.
5 mm.
595 mm.
545 mm.
24 mm.
! The appliance must not come into contact with
electrical parts once it has been installed.
The consumption indications on the data plate have
been calculated for this type of installation.
45 mm.
560 mm.
3
Electrical connections
• The appliance is earthed and the plug is
GB
compliant with the law.
! Ovens equipped with a three-pole power supply
• The socket can withstand the maximum power of
cable are designed to operate with alternating
the appliance, which is indicated on the data plate
current at the voltage and frequency indicated on
(
see below
).
the data plate located on the appliance (
see below
).
• The voltage must be in the range between the
values indicated on the data plate (
see below
).
Fitting the power supply cable
• The socket is compatible with the plug of the
appliance. If the socket is incompatible with the
1. Open the terminal
plug, ask an authorised technician to replace it. Do
board by inserting a
not use extension cords or multiple sockets.
screwdriver into the
side tabs of the cover.
! Once the appliance has been installed, the power
Use the screwdriver as
supply cable and the electrical socket must be easily
a lever by pushing it
accessible.
down to open the cover
(
see diagram
).
! The cable must not be bent or compressed.
2. Install the power
supply cable by
! The cable must be checked regularly and replaced
loosening the cable
by authorised technicians only (
see Assistance
).
clamp screw and the
three wire contact
! The manufacturer declines any liability should
screws L-N-
.
these safety measures not be observed.
Connect the wires to
the corresponding
DATA PLATE
terminals: the Blue wire
to the terminal marked
width cm 43.5
(N), the Brown wire to
Dimensions
height cm 32
depth cm 40
the terminal marked (L)
and the Yellow/Green
wire to the terminal
Volume
marked
(
see diagram
).
3. Secure the cable by fastening the clamp screw.
Electrical
voltage: 220-240V~ 50/60Hz
4. Close the cover of the terminal board.
connections
maximum power absorbed 2800W
Connecting the supply cable to the mains
Directive 2002/40/EC on the label
of electric ovens.
Install a standardised plug corresponding to the load
Norm EN 50304
Energy consumption for Natural
indicated on the data plate (
see side
).
convection – heating mode:
The appliance must be directly connected to the
ENERGY LABEL
Traditional mode
mains using an omnipolar circuit-breaker with a
minimum contact opening of 3 mm installed between
Declared energy consumption for
the appliance and the mains, suitable for the load
Forced convection Class – heating
mode: Baking
indicated and complying with current electrical
regulations (the earthing wire must not be interrupted
This appliance conforms to the
by the circuit-breaker). The supply cable must not
following European Economic
come into contact with surfaces with temperatures
Community directives:
higher than 50°C.
- 2006/95/EEC of 12/12/06 (Low
Voltage) and subsequent
! The installer must ensure that the correct electrical
amendments;
- 2004/108/EEC of 15/12/04
connection has been made and that it is compliant
(Electromagnetic Compatibility) and
with safety regulations.
subsequent amendments;
- 93/68/EEC of 22/07/93 and
Before connecting to the power supply, make sure
subsequent amendments.
that:
- 2002/96/EC and subsequent
amendments.
4
L
N
lt. 60
Оглавление
- Operating Instructions
- Installation
- Description of the appliance
- Start-up and use
- The electronic cooking programmer
- Precautions and tips
- Maintenance and care
-
-
-
-
-
-
-