Indesit FA 757 J K.A IX: Maintenance and care

Maintenance and care: Indesit FA 757 J K.A IX

Maintenance and care

3. Grip the door on the two

Switching the appliance off

external sides and close it

GB

approximately half way. Then

Disconnect your appliance from the electricity

pull the door towards you

supply before carrying out any work on it.

lifting it out of its seat (

see

diagram

).

To replace the door, reverse

Cleaning the appliance

this sequence.

Inspecting the seals

Check the door seals around the oven periodically. If

! Never use steam cleaners or pressure cleaners on

the seals are damaged, please contact your nearest

the appliance.

After-sales Service Centre (

see Assistance

). We

The stainless-steel or enamel-coated external

recommend not using the oven until the seals have

parts as well as the rubber seals may be cleaned

been replaced.

using a sponge that has been soaked in

lukewarm water and neutral soap. If these stains

Replacing the light bulb

are difficult to remove, use only specialised

To replace the oven light bulb:

products. After cleaning, rinse and dry

thoroughly. Do not use abrasive powders or

corrosive substances.

Ideally, the inside of the oven should be cleaned

after each use, when it is still lukewarm. Use hot

water and detergent, rinse and dry with a soft

cloth. Do not use abrasive products.

The accessories can be washed like everyday

crockery (even in your dishwasher).

Cleaning the oven door

1. Remove the glass cover of the lamp-holder.

2. Remove the light bulb and replace it with a similar

Clean the glass part of the oven door using a

one: Wattage 25 W, cap E 14.

sponge and a non-abrasive cleaning product, then

3. Replace the glass cover (

see diagram

).

dry thoroughly with a soft cloth. Do not use rough

! Do not use the oven lamp as/for ambient

abrasive material or sharp metal scrapers as these

lighting

could scratch the surface and cause the glass to

crack.

.

WARNING! The oven is provided with

To clean more thoroughly, you can remove the oven

a stop system to extract the racks and

door.

prevent them from coming out of the

oven.(1)

1. Open the oven door fully

As shown in the drawing, to extract them

(

see diagram

)

completely, simply lift the racks, holding

them on the front part, and pull (2).

2. Lift up and turn the small

levers located on the two

hinges (

see diagram

)

Assistance

! Never use the services of an unauthorised

technician.

Please have the following information handy:

The type of problem encountered.

The appliance model (Mod.).

The serial number (S/N).

The latter two pieces of information can be found on

the data plate located on the appliance.

10