Indesit WITL 86: инструкция

Instructions for use

WASHING MACHINE

GB

Contents

GB

CIS

ES

ES

Installation, 2-3

English, 1

ÐÓÑÑÊÈÉ, 13

Español, 25

Unpacking and levelling, 2

Electric and water connections, 2-3

The first wash cycle, 3

Technical details, 3

ES

HU

CZ

SK

Washing machine description, 4-5

Magyar, 37

Èeský, 49

Slovenský, 61

Control panel, 4

How to open and shut the drum, 5

Leds, 5

ES

Starting and Programmes, 6

Briefly: how to start a programme, 6

Programme table, 6

WITL 86

Personalisations, 7

Setting the temperature, 7

Setting the spin cycle, 7

Functions, 7

Detergents and laundry, 8

Detergent dispenser, 8

Bleach cycle, 8

Preparing your laundry, 8

Special items, 8

Precautions and advice, 9

General safety, 9

Disposal, 9

Saving energy and respecting the environment, 9

Care and maintenance, 10

Cutting off the water or electricity supply, 10

Cleaning your appliance, 10

Caring for your appliance door and drum, 10

Cleaning the pump, 10

Checking the water inlet hose, 10

Cleaning the detergent dispenser, 10

Troubleshooting, 11

Service, 12

Before calling for Assistance, 12

1

Installation

GB

 Keep this instruction manual in a safe place for

Levelling your appliance correctly will provide it with

future reference. Should the appliance be sold,

stability and avoid any vibrations, noise and shifting

transferred or moved, make sure the instruction

during operation. If it is placed on a fitted or loose

manual accompanies the washing machine to inform

carpet, adjust the feet in such a way as to allow

the new owner as to its operation and features.

enough room for ventilation beneath the washing

machine.

 Read these instructions carefully: they contain vital

Putting your appliance in place and moving it.

information on installation, use and safety.

If your washing

machine is equipped

Unpacking and levelling

with a special set of

retractable wheels you

Unpacking

can easy move it. To

lower the wheels and

1. Unpack the washing

thus move the

machine.

appliance effortlessly,

2. Check whether the

just pull the lever,

washing machine has

situated on the left-

been damaged during

hand side beneath the

transport. If this is the

base. Once the appliance is in the required

case, do not install it

position, put the lever back in place. The washing

and contact your

machine is now firmly in place (see figure).

retailer.

Electric and water connections

3. Remove the four

protective screws and

Connecting the water inlet hose

the rubber washer with

1. Insert seal A into

the respective spacer,

the end of the inlet

situated on the rear of

hose and screw the

the appliance (see

latter onto a cold

figure).

water tap with a 3/4

4. Seal the gaps using the plastic plugs provided.

A

gas threaded mouth

5. Keep all the parts: you will need them again if the

(see figure).

Before making the

washing machine needs to be moved to another

connection, allow the

location.

water to run freely

until it is perfectly

Warning: should the screws be re-used, make sure

clear.

you fasten the shorter ones at the top.

 Packaging materials are not children's toys.

2. Connect the other

end of the water inlet

Levelling

hose to the washing

machine,

1. Install the washing

screwing it onto the

machine on a flat sturdy

appliance's cold water

floor, without resting it

inlet, situated on the top

up against walls,

right-hand side on the

furniture cabinets or

rear of the appliance

other.

(see figure).

2. If the floor is not

3. Make sure there are no kinks or bends in the

perfectly level, compen-

hose.

sate for any unevenness

 The water pressure at the tap must be within the

by tightening or

values indicated in the Technical details table

loosening the adjustable

(on the next page).

front feet (see figure); the angle of inclination,

 If the water inlet hose is not long enough,

measured according to the worktop, must not

contact a specialist store or an authorised

exceed 2°.

serviceman.

2

Connecting the drain hose

 Do not use extensions or multiple sockets.

GB

Connect the drain hose,

 The power supply cable must never be bent or

without bending it, to a

dangerously compressed.

draining duct or a wall

drain situated between

 The power supply cable must only be replaced by

65 and 100 cm from

an authorised serviceman.

65 - 100 cm

the floor;

Warning! The company denies all liability if and when

these norms are not respected.

The first wash cycle

Once the appliance has been installed, and before

alternatively, place it

you use it for the first time, run a wash cycle with

over the edge of a

detergent and no laundry, setting the 90°C

basin, sink or tub,

programme without a pre-wash cycle.

fastening the duct

supplied to the tap (see

figure). The free end of

the hose should not be

underwater.

 We advise against the use of hose extensions; in

case of absolute need, the extension must have the

same diameter as the original hose and must not

Technical details

exceed 150 cm in length.

Model

WITL 86

Electric connection

40 cm wide

Before plugging the appliance into the mains

Dimensions

85 cm high

socket, make sure that:

60 cm deep

 the socket is earthed and in compliance with the

Capacity

from 1 to 5 kg

applicable law;

Electric

voltage 220/230 Volts 50 Hz

 the socket is able to sustain the appliance's

connections

maximum absorbed power 1850 W

maximum power load indicated in the Technical

maximum pressure 1 MPa (10 bar)

Water

details table (on the right);

minimum pressure 0.05 MPa (0.5 bar)

connections

drum capacity 42 litres

 the supply voltage is included within the values i

Spin speed

up to 800 rpm

ndicated on the Technical details table

(on the right);

Control

programmes

programme 2; temperature 60°C;

according to

run with a load of 5 kg.

 the socket is compatible with the washing

IEC456 directive

machine's plug. If this is not the case, replace

the socket or the plug.

This appliance is compliant with the

following European Community

 The washing machine should not be installed in an

Directives:

outdoor environment, not even when the area is

- 73/23/CEE of 19/02/73 (Low

Voltage) and subsequent amendments

sheltered, because it may be very dangerous to

- 89/336/CEE of 03/05/89

ServiceTroubleshootingPrecautions CareProgrammes DetergentsInstallation Description

leave it exposed to rain and thunderstorms.

(Electromagnetic Compatibility) and

subsequent amendments

 When the washing machine is installed, the mains

- 2002/96/CE

socket must be within easy reach.

3