Indesit K6G20 W: Routine Maintenance and Cleaning

Routine Maintenance and Cleaning

Before each operation, disconnect the appliance from

Replacing the Oven Lamp

the electrical power supply. To ensure that the appli-

• Disconnect the cooker from the power supply by means

ance lasts a long time, it must be thoroughly cleaned fre-

of the omnipolar switch used to connect the cooker to

quently, keeping in mind that:

the electrical mains; or disconnect the plug if it is ac-

· Do not use steam equipment to clean the appliance.

cessible.

• Remove the glass cover of the lamp-holder.

• The enamelled parts and the self-cleaning panels

• Remove the lamp and replace it with a lamp resistant

should be washed with warm water, without using any

to high temperatures (300°C) with the following speci-

abrasive powders or corrosive substances which could

fications:

ruin them;

- Voltage: 230V

• The inside of the oven should be cleaned fairly often

- Wattage: 25W

while it is still warm, using warm water and detergent

- Socket: E14

followed by careful rinsing and drying;

• Replace the glass cover and connect the oven to the

• The flame spreaders should be washed frequently with

mains.

hot water and detergent, taking care to eliminate any

buildup;

• On cookers equipped with automatic lighting, the ter-

minal part of the electronic instant lighting devices

should be cleaned frequently and the gas outlet holes

on the flame spreaders should be checked to make

sure they are free of any obstructions;

• Stainless steel may become marked if it comes into

contact with very hard water or harsh detergents (con-

taining phosphorous) for long periods of time. After

cleaning, it is advisable to rinse thoroughly and dry. It

is also recommended that drops of water be dried.

N.B.: Avoid closing the cover while the gas burners

are still warm.Remove any liquid from the lid before

Gas tap maintenance

opening it.

The taps may jam in time or they may become difficult to

Important: Periodically check the wear of the gas hose

turn. If so, the tap itself must be replaced.

and substitute it if there are any defects; we recommend

N.B.: This operation must be performed by a technician

changing it every year.

authorised by the manufacturer.

22