Indesit PWDE 7125 S: Troubleshooting

Troubleshooting

Your washer-dryer could occasionally fail to work. Before contacting the Technical Assistance Service (see 

GB

Service), make sure that the problem cannot be not solved easily using the following list.

Problem:

Possible causes / Solutions:

The washer-dryer does not

 The appliance is not plugged into the socket fully, or not enough to make

switch on.

contact.

 There is no power in the house.

The wash cycle does not start.

 The washer-dryer door is not closed properly.

 The ON/OFF button has not been pressed.

 The START/PAUSE button has not been pressed.

 The water tap has not been opened.

 A delayed start has been set.

The washer-dryer does not fill

 The water inlet hose is not connected to the tap.

with water (the text H2O

 The hose is bent.

flashes on the display).

 The water tap has not been opened.

 There is no water supply in the house.

 The pressure is too low.

 The START/PAUSE button has not been pressed.

The washer-dryer continuously

 The drain hose is not fitted at a height between 65 and 100 cm from the floor

takes in and drains water.

(see Installation).

 The free end of the hose is under water (see Installation).

 The wall drainage system is not fitted with a breather pipe.

If the problem persists even after these checks, turn off the water tap, switch the

appliance off and contact the Technical Assistance Service. If the dwelling is on one

of the upper floors of a building, there may be problems relating to water drainage,

causing the washer-dryer to fill with water and drain continuously. Special anti-

draining valves are available in shops and help to prevent this inconvenience.

The washer-dryer does not

 The wash cycle does not include draining: some cycles require the draining

drain or spin.

process to be enabled manually.

 The EASY IRON option is enabled: To complete the wash cycle, press the

START/PAUSE button (see Wash cycles and options).

 The drain hose is bent (see Installation).

 The drainage duct is clogged.

The washer-dryer vibrates a lot

 The drum was not unlocked correctly during installation (see Installation).

during the spin cycle.

 The washer-dryer is not level (see Installation).

 The washer-dryer is trapped between cabinets and walls (see Installation).

The washer-dryer leaks.

 The water inlet hose is not screwed on properly (see Installation).

 The detergent dispenser drawer is blocked (for cleaning instructions, see Care

and maintenance).

 The drain hose is not fixed properly (see Installation).

The option and START/PAUSE

 Switch off the machine and unplug it, wait for approximately 1 minute and

indicator lights flash rapidly and

then switch it back on again.

an error code appears on the

If the problem persists, contact the Technical Assistance Service.

display (e.g.: F-01, F-..).

There is too much foam.

 The detergent is not suitable for machine washing (it should display the text

for washer-dryers or hand and machine wash, or the like).

 Too much detergent was used.

The washer-dryer does not dry.

 The appliance is not plugged into the socket, or not enough to make contact.

 There has been a power failure.

 The appliance door is not shut properly.

 A DELAY TIMER has been set.

 DRYING is in the OFF position.

11