Pioneer F-F3MK2-K: POWER-CORD CAUTION IMPORTANT: THE MOULDED PLUG

01_F-F3MK2_en.book 3 ページ ２００９年４月３日　金曜日　午後１時４５分

CAUTION

POWER-CORD CAUTION

The POWER switch on this unit will not completely

Handle the power cord by the plug. Do not pull out the

shut off all power from the AC outlet. Since the

plug by tugging the cord and never touch the power

power cord serves as the main disconnect device for

cord when your hands are wet as this could cause a

the unit, you will need to unplug it from the AC outlet

short circuit or electric shock. Do not place the unit, a

to shut down all power. Therefore, make sure the

piece of furniture, etc., on the power cord, or pinch the

unit has been installed so that the power cord can

cord. Never make a knot in the cord or tie it with other

be easily unplugged from the AC outlet in case of an

cords. The power cords should be routed such that they

accident. To avoid fire hazard, the power cord should

are not likely to be stepped on. A damaged power cord

also be unplugged from the AC outlet when left

can cause a fire or give you an electrical shock. Check

unused for a long period of time (for example, when

the power cord once in a while. When you find it

on vacation).

D3-4-2-2-2a_A_En

damaged, ask your nearest PIONEER authorized

service center or your dealer for a replacement.

S002*_En

Information for users on collection and disposal of old equipment and used batteries

Symbol for

These symbols on the products, packaging, and/or accompanying documents mean

equipment

that used electrical and electronic products and batteries should not be mixed with

general household waste.

For proper treatment, recovery and recycling of old products and used batteries,

please take them to applicable collection points in accordance with your national

legislation.

By disposing of these products and batteries correctly, you will help to save valuable

Symbol examples

resources and prevent any potential negative effects on human health and the

for batteries

environment which could otherwise arise from inappropriate waste handling.

For more information about collection and recycling of old products and batteries,

please contact your local municipality, your waste disposal service or the point of sale

where you purchased the items.

These symbols are only valid in the European Union.

For countries outside the European Union:

If you wish to discard these items, please contact your local authorities or dealer and

ask for the correct method of disposal.

Pb

K058a_A1_En

Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified

service personnel.

IMPORTANT: THE MOULDED PLUG

This appliance is supplied with a moulded three pin mains plug for your safety and convenience. A 10 amp fuse is fitted in this plug. Should

the

fuse need to be replaced, please ensure that the replacement fuse has a rating of 10 amps and that it is approved by ASTA or BSI to BS1362.

Check for the ASTA mark or the BSI mark on the body of the fuse.

If the plug contains a removable fuse cover, you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug

must not be used until a replacement cover is obtained. A replacement fuse cover can be obtained from your local dealer.

If the fitted moulded plug is unsuitable for your socket outlet, then the fuse shall be removed and the plug cut off and disposed of

safely. There is a danger of severe electrical shock if the cut off plug is inserted into any 13 amp socket.

If a new plug is to be fitted, please observe the wiring code as shown below. If in any doubt, please consult a qualified electrician.

IMPORTANT: The wires in this mains lead are coloured in accordance with the following code:

Blue : Neutral Brown : Live

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in

your plug, proceed as follows ;

The wire which is coloured BLUE must be connected to the terminal which is marked with the

letter N or coloured BLACK.

The wire which is coloured BROWN must be connected to the terminal which is marked with the

letter L or coloured RED.

How to replace the fuse: Open the fuse compartment with a screwdriver and replace the fuse.

D3-4-2-1-2-2_B_En