Pioneer F-F3MK2-K: Last function memory Initialization of the microprocessor
Last function memory Initialization of the microprocessor: Pioneer F-F3MK2-K
Table of contents
- IMPORTANT
- POWER-CORD CAUTION IMPORTANT: THE MOULDED PLUG
- Chapter 1: Before you start Features What’s in the box
- Inserting the battery Installing the tuner
- Chapter 2: Connections Connecting antennas Making cable connections
- Connections02
- Connecting analog audio sources Plugging in
- Chapter 3: Controls and displays Front panel
- Remote control unit
- Controls and displays03
- Chapter 4: Listening to FM/AM Auto preset memory DEFAULT VALUE
- Manual tuning Search Mode Auto tuning
- Improving FM stereo sound Recalling preset stations
- Preset stations
- An introduction to RDS RDS Search/PTY Search/TP Search
- Naming station presets
- Last function memory Initialization of the microprocessor
- Chapter 5: Other connections Connecting external antennas Operating this tuner with the remote sensor of your Pioneer amplifier
- Chapter 6: Additional information Troubleshooting
- Additional information06 Problem Remedy
- Specifications
Listening to FM/AM 04
English
Last function memory
Initialization of the
• This unit is equipped with a last function
microprocessor
memory which stores the input and output
• When the indication of the display is not
setting conditions as they were
normal or when the operation of the unit
immediately before the power is switched
does not shows the reasonable result, the
off.
initializaton of the microprocessor is
This function eliminates the need to
required by the following procedure.
perform complicated resettings when the
1 Press the unit’s
POWER
button to turn
power is switch on.
the power off.
• The unit is also equipped with a back-up
FrançaisDeutsch
memory.
2 Press the unit’s
POWER
button to turn
the power on while holding down the
MENU
This function provides approximately two
button.
week of memory storage when the main
unit’s POWER button is off and with the
3“
Memory Clear?
” will be displayed in the
power cord disconnected.
display. Using the unit’s
TUNING/PRESET
Italiano Español
dial, select either “
Yes
” or “
No
” and press the
TUNING/PRESET
dial.
4If “
Yes
” is selected, the memory will be
cleared and the unit will then be set to
standby mode. If “
No
” is selected, the unit
Nederlands
1
will be set to standby mode.
19
En
Note
01_F-F3MK2_en.book 19 ページ ２００９年４月３日 金曜日 午後１時４５分
1 • If step 4 does not work, start over from step 1.
• If the microprocessor has been reset, all the button settings are reset to the default values (the values set upon shipment
from the factory).
