Asus V3-M3A3200: Removing the bay covers and reinstalling the front panel assembly and side cover

4. For SATA HDD: Connect the SATA

SATA IDE

signal and power plugs to the

English

connectors at the back of the drive.

For IDE HDD: Connect the IDE and

power plugs to the connectors at the

back of the drive.

Removing the bay covers and reinstalling the

front panel assembly and side cover

Ifyouinstalledanopticaland/oroppydiskdrive,removethebaycover(s)onthe

front panel assembly before reinstalling it to the chassis. To do this:

1. Locate the bay cover locks.

2. Press the locks outward to release

the bay cover.

3. Push the bay cover inward, then set

it aside.

4. Follow the same instructions to

remove the 3.5” drive bay cover.

To reinstall the front panel assembly and side cover:

1. Insert the front panel assembly hinge-like tabs to the holes on the right side

of the chassis.

2. Swing the front panel assembly to the left, then insert the hooks to the

chassisuntilthefrontpanelassemblytsinplace.

3. Insert the six side cover hooks into the chassis tab holes .

4. Pushthesidecovertothedirectionofthefrontpaneluntilittsinplace.

5. Secure the cover with two screws you removed earlier.

1

2

5

Air duct

2

1

4

5

1

2

3

2

Chassis tab holes

10

Installation manual