Kenwood KRC-394: Troubleshooting Guide

KRC-394(E2)_U.S r1 02.9.26 7:29 PM Page 30

Troubleshooting Guide

If the following situations, consult your nearest service

E-99: Something is wrong with the disc magazine. Or the

center:

unit is malfunctioning for some reason.

E99

• Even though the disc changer is connected, the Disc Changer source is

➪

Check the disc magazine. And then press the reset

not ON, with "AUX" showing in the display during the Changer Mode.

button on the unit. If the "E-99" code does not

English

• Even though no device (KCA-S210A, CA-C1AX, KDC-CPS89, KDC-CPS87,

disappear, consult your nearest service center.

KDC-CX87, KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is

connected, the Auxiliary input is entered when switching modes.

HOLD: The protective circuit in the unit activates when the

temperature inside the automatic disc changer

exceeds 60°C (140°F), stopping all operation.

E0d

➪

Cool down the unit by opening the windows or

The following messages are displayed when your

turning on the air conditioner. As the temperature

system condition.

falls below 60°C (140°F), the disc will start playing

again.

EJECT: No disc magazine has been loaded in the changer.

The disc magazine is not completely loaded.E01

NO NAME: Attempted to display DNPS during the CD play having

➪

Load the disc magazine properly.

no disc names preset.

E51

No CD in the unit.

➪ Insert the CD.

NO TITLE: Attempted to display the disc title or track title while

the MD having no MD title is being played.E53

NO DISC: No disc has been loaded in the disc magazine.

E02

➪

Load a disc into the disc magazine.

NO TEXT: Attempted to display the disc text or track text while

the CD having no CD text is being played.E54

E-04: No disc has been loaded in the disc magazine.

E04

➪

Load a disc into the disc magazine.

LOAD: Discs are being exchanged in the Disc changer.E57

The CD is quite dirty. The CD is upside-down. The CD

(Blink): The tape player section is not operating properly.E60

2

is scratched a lot.

3

➪

Reinsert the Tape. If the tape cannot be ejected or

➪ Clean the CD and load it correctly.

the display continues to flash even when the tape

BLANK: Nothing has been recorded on the MD.

E10

has been properly reinserted, please switch off the

power and consult your nearest service center.

NO TRACK: No tracks are recorded on the MD, although it has a

title.E11

NO ACCES: After setting it in the Disc Changer, DNPP was done

without having it been played at least 1 time.

E58

NO PANEL: The faceplate of the slave unit being connected to

this unit has been removed.E30

➪

Replace it.

E-77: The unit is malfunctioning for some reason.

E77

➪

Press the reset button on the unit. If the "E- 77"

code does not disappear, consult your nearest

service center.

— 30 —