Indesit WITL-1061-(EU): Personalisations

9

GB

Personalisations

C

 Setting the temperature

Turn the TEMPERATURE knob to set the wash temperature 

(see Programme table)

.

The temperature can be lowered, or even set to a cold wash ( ).

 Setting the spin speed

Turn the SPIN SPEED knob to set the spin speed for the programme selected. 

The maximum spin speeds for each programme are as follows:

Programmes 

Maximum spin speed

Cottone  

1000 rpm 

Synthetics 

800 rpm

Wool  

800 rpm

Silk   

no

The spin speed can be lowered, or the spin cycle can be excluded altogether by selecting symbol  .

The washing machine will automatically prevent you from selecting a spin speed higher than the maximum speed for each 

programme.

Note.

 To avoid excessive vibrations, before every spin cycle the machine distributes the load in a uniform manner by continuously rotating 

the drum at a speed which is slightly faster than the normal washing speed. When, despite repeated attempts, the load is still not evenly 

distributed, the machine spins at a lower speed than the set frequency. If the load is excessively unbalanced, the machine attempts to 

distribute it instead of spinning. The balancing attempts may extend the total duration of the cycle, up to a maximum of 10 minutes.

Functions

To enable a function:

1. press the button corresponding to the desired function, according to the table below;

2. the function is enabled when the corresponding button is illuminated.

Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the programme set.

Option

Effect

Comments

Enabled with 

programmes:

Delay Timer

Delays the start of the 

wash by up to 9 hours.

Pess the button repeatedly until the LED corresponding to the 

desired delay is turned on. The fifth time the button is pressed, the 

function will be disabled.

N.B.: Once you have pressed the Start/Reset button, the delay 

can only be decreased if you wish to modify it.

All

Bleaching

Bleaching cycle de-

signed to remove the 

toughest stains.

Please remember to pour the bleach into extra compartment 4 

(see page 10).

 This option is incompatible with the EASY IRON option.

2, 3, 4, 

, 

, 

8 and

Rinse cycle.

Easy iron

By selecting this 

function, the wash 

and spin cycles will be 

modified in order to 

reduce the formation of 

creases. 

At the end of the cycle 

the washing machine 

will perform slow 

rotations of the drum.

To drain the water so that the laundry may be removed, press the 

START/RESET button.

This option is incompatible with the BLEACHING option.

1, 2, 3, 4, 

, 

, 8, 9, 10, 11.

Extra Rinse

Increases the efficiency 

of the rinse.

Recommended when the appliance has a full load or with large 

quantities of detergent.

1, 2, 3, 4, 

, 

, 7, 8, 9, 10, 

11, 13, 14, and 

Rinse cycle.