Indesit PI 604: Installation

380-400V 3N~

1 2

3

4

5

GB

H05RR-F 5x1.5 CEI-UNEL 35363

R

S

T

N

380-400V 2N~

12345

H05RR-F 4x1.5 CEI-UNEL 35363

R

S

N

220-230V 1N~

1

2

3

4

5

H05RR-F 3x2.5 CEI-UNEL 35363

R

N

Where a hob is installed above an oven without a

Connecting the supply cable to the mains

forced ventilation cooling system, adequate ventilation

must be provided inside the cabinet by means of air

Install a standardised plug corresponding to the load

holes through which air can pass (see figure).

indicated on the data plate.

The appliance must be directly connected to the mains

using an omnipolar circuit-breaker with a minimum

contact opening of 3 mm installed between the

appliance and the mains. The circuit-breaker must be

suitable for the charge indicated and must comply with

current electrical regulations (the earthing wire must not

be interrupted by the circuit-breaker). The supply cable

must not come into contact with surfaces with

temperatures higher than 50°C.

Electrical connection

! The installer must ensure that the correct electrical

connection has been made and that it is compliant

The electric hobs are supplied without power supply

with safety regulations.

cable since the cable must be sized according to the

Before connecting to the power supply, make sure

type of electrical connection used (see attached

that:

connection diagram). Follow these steps to connect

the cable:

• The appliance is earthed and the plug is compliant

with the law.

• Open the terminal box by removing the screws "V"

and opening the cover (see figure).

• The socket can withstand the maximum power of

the appliance, which is indicated on the data plate.

• Connect the wires as shown in the diagram.

• The voltage is in the range between the values

• Fix the cable using the cable clamp "F", replace the

indicated on the data plate.

cover and fasten it using the screws "V" (see figure).

• The socket is compatible with the plug of the

V

1

2

3

4

5

appliance. If the socket is incompatible with the

plug, ask an authorised technician to replace it. Do

not use extension cords or multiple sockets.

! Once the appliance has been installed, the power

supply cable and the electrical socket must be easily

accessible.

! The cable must not be bent or compressed.

F

! The cable must be checked regularly and replaced

by authorised technicians only (see Assistance).

! The manufacturer declines any liability should these

safety measures not be observed.

! If the appliance is to be installed above a built-in

electric oven, the electrical connection of the hob and

the oven must be carried out separately, both for

electrical safety purposes and to make extracting the

oven easier.

10