Indesit H563IX: English

English  

11 

EN

! 

It is important to conserve this booklet for consultation at any moment. In 

the case of sale, cession or move, make sure it is together with the product.   

! 

Read the instructions carefully: there is important information about 

installation, use and safety.  

! 

Do not carry out electrical or mechanical variations on the product or on the 

discharge conduits. 

GENERAL SAFETY 

The minimum distance between the supporting surface for the cooking 

equipment on the hob and the lowest part of the range hood must be not less 

than 60cm from electric cookers and 70cm from gas or mixed cookers. 

If the instructions for installation for the gas hob specify a greater distance, this 

must be adhered to. 

Expansion wall plugs are provided to secure the hood to most types of 

walls/ceilings. However, a qualified technician must verify suitability of the 

materials in accordance with the type of wall/ceiling. The wall/ceiling must be 

strong enough to take the weight of the hood. 

Do not tile, grout or silicone this 

appliance to the wall. Surface mounting only. 

WARNING!

 Do not connect the appliance to the mains until the installation is 

fully complete.  

Before any cleaning or maintenance operation, disconnect hood from the mains 

by removing the plug or disconnecting the mains electrical supply.  

Always wear work gloves for all installation and maintenance operations. 

The appliance is not intended for use by children or persons with impaired 

physical, sensorial or mental faculties, or if lacking in experience or know-how, 

unless they are under supervision or have been trained in the use of the 

appliance by a person responsible for their safety. 

Children should be monitored to ensure that they do not play with the appliance. 

This appliance is designed to be operated by adults.  Children should not be 

allowed to tamper with the controls or play with the appliance.Never use the 

hood without effectively mounted grating! 

The hood must NEVER be used as a support surface unless specifically 

indicated. 

The premises where the appliance is installed must be sufficiently ventilated, 

when the kitchen hood is used together with other gas combustion devices or 

other fuels.  

The suctioned air must not be conveyed into a conduit used for the disposal of 

the fumes generated by appliances that combust gases or other fuels. 

The flaming of foods beneath the hood itself is severely prohibited. 

The use of exposed flames is detrimental to the filters and may cause a fire risk, 

and must therefore be avoided in all circumstances.  

Any frying must be done with care in order to make sure that the oil does  not 

overheat and burst into flames. 

With regards to the technical and safety measures to be adopted for fume 

discharging it is important to closely follow the regulations provided by the 

authorised authorities. 

The hood must be regularly cleaned on both the inside and outside (AT LEAST 

ONCE A MONTH). 

This must be completed in accordance with the maintenance instructions 

provided in this manual). Failure to follow the instructions provided in this user 

guide regarding the cleaning of the hood and filters will lead to the risk of fires. 

Do not use or leave the hood without the lamp correctly mounted due to the 

possible risk of electric shocks. 

We will not accept any responsibility for any faults, damage or fires caused to the 

appliance as a result of the non-observance of the instructions included in this 

manual. 

ELECTRICAL CONNECTION 

The mains power supply must correspond to the rating indicated on the plate 

situated inside the hood. If provided with a plug connect the hood to a socket in 

compliance with current regulations and positioned in an accessible area. If it not 

fitted with a plug (direct mains connection) or if the plug is not located in an 

accessible area apply a double pole switch in accordance with standards which 

assures the complete disconnection of the mains under conditions relating to 

over-current category III, in accordance with installation instructions. 

Warning! 

Before re-connecting the hood circuit to the mains supply and 

checking the efficient function, always check that the mains cable is correctly 

assembled. 

Replacing the power cable 

Warning! 

Power cable replacement must be undertaken  by the authorised 

service assistance centre or similar qualified person. 

AIR VENT 

(for the suction versions) 

Connect the hood and discharge holes on the walls with a diameter equivalent to 

the air outlet (connection flange). 

Using the tubes and discharge holes on walls with smaller dimensions will cause 

a diminution of the suction performance and a drastic increase in noise. 

Any responsibility in the matter is therefore declined.  

! 

Use a duct of the minimum indispensible length. 

! 

Use a duct with as few elbows as possible (maximum elbow angle: 90°). 

! 

Avoid drastic changes in the duct cross-section. 

! 

Use a duct with an as smooth as possible inside. 

! 

The duct must be made of certified material. 

!

The company declines any responsibility whenever these regulations are 

not respected. 

FILTERING OR DUCTING ? 

!

Your cooker hood is ready to be used in suction version. 

To use the hood in filtering version the special ACCESSORY KIT must be 

installed. 

Check on the first pages of this manual if the ACCESSORY KIT is furnished 

or must be bought separately. 

Note:

 If furnished, in certain cases, the additional activated carbon filtering 

system may be installed on the hood. 

Information about the conversion of the hood from suction version to filtering 

version is present in this manual. 

  Ducting version 

In this case the fumes are conveyed outside by means of a special pipe 

connected with the connection ring located on top of the hood. 

Attention

! The exhausting pipe is not supplied and must be purchased apart. 

Diameter of the exhausting pipe must be equal to that of the connection ring = 

150mm. 

In the horizontal runs the exhausting pipe must be slightly slanted (about 10°) 

and directed upwards to vent the air easily from the room to the outside. 

Attention! If the hood is supplied with active charcoal filter, then it must be 

removed. 

  Filter version 

Order and install 2 active carbon filters (active carbon filters are available from 

your dealer). 

The filter removes the grease and smells from the extracted air before sending it 

back into the room through the upper outlet grid. 

CONTROLS 

A.

 on/off light switch 

B.

 on/off aspiration switch and minimum power selection 

B+C.

 medium power selection aspiration switch 

B+D.

 maximum power selection aspiration switch 

E.

 operating gauge  

12 

EN 

MAINTENANCE 

ATTENTION! 

Before performing any maintenance operation, isolate the hood 

from the electrical supply by switching off at the connector and removing the 

connector fuse.  

Or if the appliance has been connected through a plug and socket, then the plug 

must be removed from the socket. 

Cleaning 

The cooker hood should be cleaned regularly (at least with the same frequency 

with which you carry out maintenance of the fat filters) internally and externally.  

Clean using the cloth dampened with neutral liquid detergent. Do not use 

abrasive products. 

DO NOT USE ALCOHOL!

WARNING: 

Failure to carry out the basic cleaning recommendations of the 

cooker hood and replacement of the filters may cause fire risks.  

Therefore, we recommend oserving these instructions. 

The manufacturer declines all responsibility for any damage to the motor or any 

fire damage linked to inappropriate maintenance or failure to observe the above 

safety recommendations. 

Maintenance of the anti-grease filters 

Traps cooking grease particles. 

This must be cleaned once a month using non aggressive detergents, either by 

hand or in the dishwasher, which must be set to a low temperature and a short 

cycle.  When washed in a dishwasher, the grease filter may discolour slightly, but 

this does not affect its filtering capacity. 

To remove the grease filter, pull the spring release handle. 

Maintenance of the charcoal filter 

It absorbs unpleasant odours caused by cooking. 

The saturation of the activated charcoal occurs after more or less prolonged use, 

depending on the type of cooking and the regularity of cleaning of the grease 

filter. 

In any case it is necessary to replace the cartridge at least every four mounths. 

The carbon filter may NOT be washed or regenerated. 

• 

Remove the grease filter. 

• 

Apply one on each side covering both grills protecting the motor propeller, 

then turn the filter central handles 

P

 clockwise.  

• 

In order to dismantle turn the central handle 

P

 anti-clockwise for each filter.  

• 

Put the grease filters back in place. 

Replacing lamps 

Disconnect the hood from the electricity. 

Warning! 

Prior to touching the light bulbs ensure they are cooled down. 

-  Remove the grease filters . 

-  Replace faulty bulbs, always using new bulbs of 

max. 40 W (E14). 

-  Refit the grease filters. 

13 

EN

DISPOSAL 

This appliance is marked according to the European directive 2002/96/EC on 

Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is 

disposed of correctly, you will help prevent potential negative consequences for 

the environment and human health, which could otherwise be caused by 

inappropriate waste handling of this product. 

The symbol 

 on the product, or on the documents accompanying the 

product, indicates that this appliance may not be treated as household waste. 

Instead it should be taken to the appropriate collection point for the recycling of 

electrical and electronic equipment. Disposal must be carried out in accordance 

with local environmental regulations for waste disposal. 

For more detailed information about treatment, recovery and recycling of this 

product, please contact your local authority. 

MALFUNCTIONS 

If something appears not to be working properly, do the following simple checks 

before calling Technical Service: 

• 

If the hood is not working: 

 Check 

that: 

- The power has not been disconnected. 

- A speed has been selected. 

• 

If the hood performs inefficiently: 

 Check 

that: 

- The motor speed selected is sufficient for the amount of smoke and 

vapours released. 

- The kitchen is sufficiently ventilated to allow air intake. 

- The charcoal filter is not worn (hood in filtering version). 

• 

If the hood has turned off during normal functioning: 

 Check 

that: 

- The power has not been disconnected. 

- the omnipolar disconnection device has not tripped. 

If the hood fails to operate correctly, briefly disconnect it from the mains power 

supply for almost 5 sec. by pulling out the plug. Then plug it in again and try once 

more before contacting the Technical Assistance Service. 

TECHNICAL DATA 

Model H 563 

Height (Ducting version) 

73,3-114,8 cm 

Height (Filter version) 

81,8-114,8 cm 

Width 

59,9 cm 

Depth 

51,5 cm 

Gross weight: 

12,15 Kg 

Total absorption 

200 W

Motor absorption 

1x120 W

Lamp absorption 

2x40 W (E14)

Exhaust pipe Ø 

15 cm

Model H 573 

Height (Ducting version) 

73,3-114,8 cm 

Height (Filter version) 

81,8-114,8 cm 

Width 

69,9 cm 

Depth 

51,5 cm 

Gross weight: 

14 Kg 

Total absorption 

200 W

Motor absorption 

1x120 W

Lamp absorption 

2x40 W (E14)

Exhaust pipe Ø 

15 cm

Model H 593 

Height (Ducting version) 

73,3-114,8 cm 

Height (Filter version) 

81,8-114,8 cm 

Width 

89,9 cm 

Depth 

51,5 cm 

Gross weight: 

14,85 Kg 

Total absorption 

200 W

Motor absorption 

1x120 W

Lamp absorption 

2x40 W (E14)

Exhaust pipe Ø 

15 cm

This appliance conforms to the following EEC Directive: 

• 

“Low Voltage Equipment” Directive 2006/95/EC (12-12-2006)  

• “Electromagnetic 

Compatibility” 

Directive 2004/108/EC (15-12-2004)  

    Components not provided with the product