Indesit H361FBK: General

32

GB

General 

Carefully read the following important information 

regarding installation safety and maintenance. Keep this 

information booklet accessible for further consultations. 

The appliance has been designed for use in the ducting 

version (air exhaust to the outside – Fig.1B), fi ltering 

version (air circulation on the inside – Fig.1A).

Safety precaution

1. 

Take care when the cooker hood is operating 

simultaneously with an open fi replace or burner that 

depend on the air in the environment and are supplied 

by other than electrical energy, as the cooker hood 

removes the air from the environment which a burner 

or fi replace need for combustion. The negative pressure 

in the environment must not exceed 4Pa (4x10-5 bar). 

Provide adequate ventilation in the environment for a 

safe operation of the cooker hood. Follow the local laws 

applicable for external air evacuation. 

Before connecting the model to the electricity net-

work:

- control the data plate (positioned inside the appliance) 

to ascertain that the voltage and power correspond to 

the network and the socket is suitable. If in doubt ask a 

qualifi ed electrician 

fi gure 1C.

- If the power supply cable is damaged, it must be replaced 

with another cable or a special assembly, which may 

be obtained direct from the manufacturer or from the 

Technical Assistance Centre.

- This device must be connected to the supply network 

through either a plug 

fused 3A 

or hardwired to a 

2 fase 

spur protected by 

3A fuse.

2. Warning!

In certain circumstances electrical appliances may 

be a danger hazard. 

A) Do not check the status of the fi lters while the 

cooker hood is operating

B) Do not touch bulbs or adjacent areas, during 

or straight after prolonged use of the lighting 

installation.

C) Flambè cooking is prohibited underneath the 

cooker hood 

D) Avoid free fl ame, as it is damaging for the fi lters 

and a fi re hazard

E) Constantly check food frying to avoid that the over-

heated oil may become a fi re hazard

F) Disconnect the electrical plug prior to any mainte-

nance.

G) This appliance is not intended for use by young 

children or infi rm persons without supervision

H) Young children should be supervised to ensure 

they do not play with the appliance

I)  There shall be adequate ventilation of the room 

when the rangehood is used at the same time as ap-

pliances burning gas or other fuels

L) There is a risk of fi re if cleaning is not carried out 

in accordance with the instructions

This appliance conforms to the European Directive 

EC/2002/96, Waste Electrical and Electronic Equipment 

(WEEE).  By making sure that this appliance is disposed 

of in a suitable manner, the user is helping to prevent 

potential damage to the environment or to public health.

The 

 symbol on the product or on the accompanying 

paperwork indicates that the appliance should not be 

treated as domestic waste, but should be delivered to 

a suitable electric and electronic appliance recycling 

collection point. Follow local guidelines when disposing 

of waste. For more information on the treatment, re-use 

and recycling of this product, please contact your local 

authority, domestic waste collection service or the shop 

where the appliance was purchased.

Installation instructions 

Assembly and electrical connections must be carried out 

by specialised personnel.  

• Electric Connection

The appliance has been manufactured as a class II, 

therefore no earth cable is necessary. 

The connection to the mains is carried out as follows: 

BROWN = 

L

 line

BLUE = 

N

 neutral

If not provided, connect a plug for the electrical load 

indicated on the description label. Where a plug is 

provided, the cooker hood must be installed in order that 

the plug is easily accessible. An omnipolar switch with a 

minimum opening of 3mm between contacts, in line with 

the electrical load and local standards, must be placed 

between the appliance and the network in the case of 

direct connection to the electrical network. 

•  The minimum distance between the support surfaces of 

the cooking pots on the cooker top and the lowest part of 

the cooker hood must be at least 65 cm. If a connection 

tube composed of two parts is used, the upper part 

must be placed outside the lower part. Do not connect 

the cooker hood exhaust to the same conductor used 

to circulate hot air or for evacuating fumes from other 

appliances generated by other than an electrical source. 

Before proceeding with the assembly operations, remove 

the anti-grease fi lter(s) (Fig.7) so that the unit is easier 

to handle.

In the case of assembly of the appliance in the suction 

General