Kenwood KRC-31: Troubleshooting Guide

Troubleshooting Guide: Kenwood KRC-31

Troubleshooting Guide

If the following situations, consult your nearest service

E-99: Something is wrong with the disc magazine. Or the

center:

unit is malfunctioning for some reason.E99

Even though the disc changer is connected, the Disc Changer source is

Check the disc magazine. And then press the reset

not ON, with "AUX" showing in the display during the Changer Mode.

button on the unit. If the "E-99" code does not

English

Even though no device (KCA-S210A, CA-C1AX, KDC-CPS89, KDC-CPS87,

disappear, consult your nearest service center.

KDC-CX87, KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is

connected, the Auxiliary input is entered when switching modes.

HOLD: The protective circuit in the unit activates when the

temperature inside the automatic disc changer

exceeds 60°C (140°F), stopping all operation.

E0d

Cool down the unit by opening the windows or

The following messages are displayed when your

turning on the air conditioner. As the temperature

system condition.

falls below 60°C (140°F), the disc will start playing

again.

EJECT: No disc magazine has been loaded in the changer.

The disc magazine is not completely loaded.

E01

NO NAME: Attempted to display DNPS during the CD play having

Load the disc magazine properly.

no disc names preset.

E51

No CD in the unit.

Insert the CD.

NO TITLE: Attempted to display the disc title or track title while

the MD having no MD title is being played.E53

NO DISC: No disc has been loaded in the disc magazine.

E02

Load a disc into the disc magazine.

NO TEXT: Attempted to display the disc text or track text while

the CD having no CD text is being played.E54

E-04: No disc has been loaded in the disc magazine.

E04

Load a disc into the disc magazine.

LOAD: Discs are being exchanged in the Disc changer.E57

The CD is quite dirty. The CD is upside-down. The CD

2

(Blink): The tape player section is not operating properly.E60

is scratched a lot.

3

Reinsert the Tape. If the tape cannot be ejected or

Clean the CD and load it correctly.

the display continues to flash even when the tape

BLANK: Nothing has been recorded on the MD.

E10

has been properly reinserted, please switch off the

power and consult your nearest service center.

NO TRACK: No tracks are recorded on the MD, although it has a

title.E11

NO ACCES: After setting it in the Disc Changer, DNPP was done

without having it been played at least 1 time.

E58

NO PANEL: The faceplate of the slave unit being connected to

this unit has been removed.E30

Replace it.

E-77: The unit is malfunctioning for some reason.

E77

Press the reset button on the unit. If the "E- 77"

code does not disappear, consult your nearest

service center.

— 30

Оглавление