Kenwood KDC-W427: Removing the Unit

Removing the Unit

Removing the hard rubber frame

Removing the Unit

1

Engage the catch pins on the removal tool and

1

Refer to the section 'Removing the hard rubber

remove the two locks on the upper level.

frame' (page 25) and then remove the hard

Upper the frame and pull it forward as shown in

rubber frame.

the figure.

2 Remove the screw (M4 × 8) on the back panel.

3 Insert the two removal tools deeply into the slots

on each side, as shown.

Screw (M4X8)

Lock

(commercially available)

Accessory2

Removal tool

2 When the upper level is removed, remove the

lower two locations.

Accessory2

Removal tool

4 Lower the removal tool toward the bottom, and

pull out the unit halfway while pressing towards

the inside.

• The frame can be removed from the bottom side in the

same manner.

• Be careful to avoid injury from the catch pins on the

removal tool.

5 Pull the unit all the way out with your hands,

being careful not to drop it.

English

|

25

B64-2807-00U.S.Inddtcsp25 03.12.11,6:27:34PM