Indesit HIM-506-EK.A-IX-2: Maintenance and care

Switching the appliance off

To replace the door, reverse this sequence.

GB

Disconnect your appliance from the electricity supply

Inspecting the seals

before carrying out any work on it.

Check the door seals around the oven periodically. If

Cleaning the appliance

the seals are damaged, please contact your nearest

After-sales Service Centre (see Assistance). We

• The stainless-steel or enamel-coated external parts

recommend not using the oven until the seals have

as well as the rubber seals may be cleaned using a

been replaced.

sponge that has been soaked in lukewarm water

and neutral soap. If these stains are difficult to

Replacing the light bulb

remove, use only specialised products. After

cleaning, rinse and dry thoroughly. Do not use

To replace the oven light bulb:

abrasive powders or corrosive substances.

• Ideally, the inside of the oven should be cleaned

after each use, when it is still lukewarm. Use hot

water and detergent, rinse and dry with a soft cloth.

Do not use abrasive products.

• The accessories can be washed like everyday

crockery (even in your dishwasher).

! Never use steam cleaners or pressure cleaners on

the appliance.

Cleaning the oven door

1. Remove the glass cover of the lamp-holder.

Clean the glass part of the oven door using a sponge

2. Remove the light bulb and replace it with a similar

and a non-abrasive cleaning product, then dry

one: Wattage 25 W, cap E 14.

thoroughly with a soft cloth. Do not use rough abrasive

3. Replace the glass cover (see diagram).

material or sharp metal scrapers as these could

scratch the surface and cause the glass to crack.

Assistance

To clean more thoroughly, you can remove the oven door.

Communicating:

1. Open the oven door fully

• appliance model (Mod.)

(see diagram).

• serial number (S/N)

This information is found on the data plate located on

the appliance and/or on the packaging.

2. lift up and turn the small

levers situated on the two

hinges; (see diagram).

3. Grip the door on the two

external sides and close it

approximately half way. Unlock

the door by pressing on the

clamps

FF

FF

F, then pull the door

towards you lifting it out of its

seat (see diagram).

12

Maintenance and care