Indesit E2SD 1160B B: Troubleshooting

Troubleshooting: Indesit E2SD 1160B B

Troubleshooting

Your washing machine could fail to work. Before contacting the Technical Assistance Centre (see “Assistance”), make sure

that the problem cannot be not solved easily using the following list.

GB

Problem:

Possible causes / Solutions:

The washing machine does not

• Theapplianceisnotpluggedintothesocketfully,orisnotmakingcontact.

switch on.

• Thereisnopowerinthehouse.

The wash cycle does not start.

• Thewashingmachinedoorisnotclosedproperly.

• TheON/OFFbuttonhasnotbeenpressed.

• TheSTART/PAUSEbuttonhasnotbeenpressed.

• Thewatertaphasnotbeenopened.

• Adelayedstarthasbeenset(see “Personalisation”).

The washing machine does not

• Thewaterinlethoseisnotconnectedtothetap.

take in water (“H2O” will flash on

• Thehoseisbent.

the display).

• Thewatertaphasnotbeenopened.

• Thereisnowatersupplyinthehouse.

• Thepressureistoolow.

• TheSTART/PAUSEbuttonhasnotbeenpressed.

The washing machine continuously

• Thedrainhoseisnotfittedataheightbetween65and100cmfromthefloor

takes in and drains water.

(see “Installation”).

• Thefreeendofthehoseisunderwater(see “Installation”).

• Thewalldrainagesystemisnotfittedwithabreatherpipe.

If the problem persists even after these checks, turn off the water tap, switch

the appliance off and contact the Assistance Service. If the dwelling is on one of

the upper floors of a building, there may be problems relating to water drainage,

causing the washing machine to fill with water and drain continuously. Special

anti-draining valves are available in shops and help to avoid this inconvenience.

The washing machine does not

• Thewashcycledoesnotincludedraining:somewashcyclesrequirethedrain

drain or spin.

phase to be started manually.

• Thedrainhoseisbent(see “Installation”).

• Thedrainageductisclogged.

The washing machine vibrates a lot

• Thedrumwasnotunlockedcorrectlyduringinstallation(see “Installation”).

during the spin cycle.

• Thewashingmachineisnotlevel(see “Installation”).

• Thewashingmachineistrappedbetweencabinetsandwalls(see “Installation”).

The washing machine leaks.

• Thewaterinlethoseisnotscrewedonproperly(see “Installation”).

• Thedetergentdispenserdrawerisblocked(forcleaninginstructions,see “Care

and maintenance”).

• Thedrainhoseisnotfixedproperly(see “Installation”).

The functionindicator lights and

• Switchoffthemachineandunplugit,waitforapproximately1minuteandthen

the start/pause indicator light flash,

switch it back on again.

while one of the phase in progress

If the problem persists, contact the Technical Assistance Service.

indicator lights and the “door locked”

indicator light will remain lit in a fixed

manner.

There is too much foam.

• Thedetergentisnotsuitableformachinewashing(itshoulddisplaythetext

“for washing machines” or “hand and machine wash”, or the like).

• Toomuchdetergentwasused.

23