Indesit E2SD 1160B B: Installation

Installation

! This instruction manual should be kept in a safe

Levelling the machine correctly will provide

GB

place for future reference. If the washing machi-

it with stability, help to avoid vibrations and

ne is sold, transferred or moved, make sure that

excessive noise and prevent it from shifting

the instruction manual remains with the machine

while it is operating. If it is placed on carpet or

so that the new owner is able to familiarise him-

a rug, adjust the feet in such a way as to allow

self/herself with its operation and features.

a sufficient ventilation space underneath the

! Read these instructions carefully: they con-

washing machine.

tain vital information relating to the safe instal-

lation and operation of the appliance.

Connecting the electricity and

Unpacking and levelling

water supplies

Unpacking

Connecting the water inlet hose

1. Remove the washing machine from its

1. Insert seal A into

packaging.

the end of the inlet

2. Make sure that the washing machine has

hose and screw the

not been damaged during the transportation

latter onto a cold wa-

process. If it has been damaged, contact the

ter tap with a 3/4 gas

retailer and do not proceed any further with

threaded mouth (see

the installation process.

figure). Before making

3. Remove the 4 pro-

the connection, allow

tective screws (used

the water to run fre-

during transportation)

ely until it is perfectly

and the rubber wa-

clear.

sher with the cor-

responding spacer,

2. Connect the inlet

located on the rear

hose to the washing

part of the appliance

machine by screwing

(see figure).

it onto the correspon-

ding water inlet of the

appliance, which is

4. Close off the holes using the plastic plugs

situated on the top

provided.

right-hand side of the

5. Keep all the parts in a safe place: you will

rear part of the ap-

need them again if the washing machine ne-

pliance (see figure).

eds to be moved to another location.

3. Make sure that the hose is not folded over

! Packaging materials should not be used as

or bent.

toys for children.

! The water pressure at the tap must fall within

Levelling

the values indicated in the Technical details

1. Install the washing machine on a flat sturdy

table (see next page).

floor, without resting it up against walls, furni-

ture cabinets or anything else.

! If the inlet hose is not long enough, contact a

2. If the floor is not

specialised shop or an authorised technician.

perfectly level, com-

pensate for any une-

! Never use second-hand hoses.

venness by tightening

or loosening the

! Use the ones supplied with the machine.

adjustable front feet

(see figure); the angle

of inclination, measu-

red in relation to the

worktop, must not

exceed 2°.

14