Kenwood CM662: English

English

Please unfold the front page illustrations

safety

key

●

Never let the cord hang down over

 hotplate

the worktop edge - a child could

 compartment for excess cord

grab it and pull the machine down.

 filter door release button

Push excess cord inside the back of

 permanent coffee filter (or use a

the machine.

paper filter instead)

●

Always make sure there is water in

 filter holder

the tank before switching on.

 filter door

●

Never use a damaged coffee maker.

 on/off switch with indicator light

Get it checked or repaired: See

(model CM650 only)

‘service’.

additional features on the

●

Never put the machine in water or let

CM660

the cord or plug get wet.

 strength control indicator light

●

Watch out for steam and never

 strength control button

touch the hotplate.

 auto/on/off indicator light

●

This machine is for domestic use

 auto/on/off button

only.

 automatic timer light

●

This machine is not intended for use

 automatic timer button

by young children or infirm persons

 hour button

without supervision.

 minute button

●

Don’t let children play with this

to set the clock (model

machine.

CM660 only)

before plugging in

(the clock does not have to be set in

●

Make sure your electricity supply is

order for the coffee maker to

the same as the one shown on the

operate)

underside of your machine.

1 Plug into the power supply.

●

This machine complies with

2 Press the hour and minute buttons

European Economic Community

until the correct time is shown. Make

Directive 89/336/EEC.

sure when selecting the hour that

AM or PM is correctly selected.

before using for the first time

●

Providing the appliance remains

1 Remove all packaging.

connected to the power supply the

2 Wash the parts: see ‘care and

clock will keep the correct time, if it

cleaning’.

is unplugged the clock will flash

3. Push excess cord inside the back of

12:00.

the machine.

4. Run two lots of water through the

to make coffee

machine (without coffee) to clean it

1 Pour water into the tank. The water

out. Fill the tank to the top cup mark

must be between the top and

when you do this. See ‘to make

bottom cup marks. Then close the

coffee’.

lid.

●

Use cold water. We recommend

using filtered water from a Kenwood

Water Filter as it reduces limescale.

Never use warm or fizzy water.

●

If you use the jug to fill the tank, look

at the tank marks, not the jug marks.

They’re slightly different to allow for

the fact that some of the water gets

2

absorbed by the coffee.

selected.

2 Open the filter door by pressing the

3 Release the automatic timer button.

release button and insert the filter

4 Press the auto/on/off button once.

holder.

The automatic timer light will glow.

3 Add either a permanent filter or a

●

When the set brewing time is

paper filter. Add the coffee

reached the coffee maker will

(approximately 1 rounded

operate, the automatic timer light will

dessertspoon/7g per cup). Then

go out and the auto/on/off light will

close the filter door.

come on.

4 Put the jug on the hotplate.

5 Plug in and switch on.

care & cleaning

●

Model CM650 press the on/off

●

Always switch off and unplug before

switch. The light will come on.

cleaning.

●

Model CM660 press the

●

Never put the machine in water or let

auto/on/off button twice. The light

the cord or plug get wet.

will come on.

6 CM660: to produce stronger coffee

jug, lid, filter holder,

press the strength control button.

permanent filter

●

During operation the strength control

●

Wash, then dry.

indicator light will glow for

body, filter door

approximately 10 minutes.

●

Wipe with a damp cloth, then dry.

7 Don’t remove the jug until brewing

Don’t use abrasives - they’ll scratch

has finished. The hotplate will keep

the plastic.

your coffee hot, but the sooner you

drink it, the better it will taste.

descaling

●

Model CM660 After 2 hours,

You’ll know when limescale has built

power to the hotplate will cease and

up because your coffee will take

the auto/on/off indicator light will go

longer to come through. When this

out.

happens it’s time to descale.

8 When the jug’s empty, switch off by

pressing the on/off switch (CM650)

to descale

or the auto/on/off button (CM660).

1 Buy a suitable descaler.

Let the machine cool down before

2 Descale the machine.

cleaning.

3 After descaling, run several lots of

●

If you haven’t used the machine for

water through the machine to clean

a while, run one lot of water through

it out. Fill the tank to the top cup

it (without coffee) to clean it out. Fill

mark when you do this.

the tank to the top cup mark when

4 Wash the parts.

you do this.

●

Never put the jug in the microwave.

service

●

to use the automatic timer

If the cord is damaged it must, for

(model CM660 only)

safety reasons, be replaced by

1 Set the correct time.

Kenwood or an authorised Kenwood

2 Press the automatic timer button

repairer.

and at the same time adjust the

If you need help with:

Hour and Minute buttons to display

●

using your machine or

the time you want the coffee maker

●

servicing, spare parts or repairs

to come into operation. Make sure

contact the shop where you bought

that the desired AM or PM is

your machine.

3