Indesit FMR 54 K.A AV: Precautions and tips
Precautions and tips: Indesit FMR 54 K.A AV

Disposal
Precautions and tips
GB
legislation so that the packaging may be reused.
! This appliance has been designed and manufactured
in compliance with international safety standards. The
following warnings are provided for safety reasons and
that old household electrical appliances must not
must be read carefully.
be disposed of in the normal unsorted municipal
waste stream. Old appliances must be collected
General safety
separately in order to optimise the recovery and
recycling of the materials they contain and reduce
home and is not intended for commercial or industrial use.
the impact on human health and the environment.
The crossed out “wheeled bin” symbol on the product
covered areas. It is extremely dangerous to leave the
reminds you of your obligation, that when you dispose
appliance exposed to rain and storms.
of the appliance it must be separately collected.
Consumers should contact their local authority or retailer
the handles provided on the sides of the oven.
for information concerning the correct disposal of their
old appliance.
damp hands and feet.
The appliance must be used by adults only for
Respecting and conserving the
the preparation of food, in accordance with the
environment
instructions provided in this booklet. Any other
use of the appliance (e.g. for heating the room)
supply network companies by using the oven in the
constitutes improper use and is dangerous. The
hours between late afternoon and the early hours of
manufacturer may not be held responsible for any
the morning. The cooking mode programming options,
damage caused as a result of improper, incorrect
and unreasonable use of the appliance.
Do not touch the heating elements or certain parts
of the oven door when the appliance is in use; these
from the appliance.
and GRATIN modes: This will achieve improved results
appliances do not come into contact with the hot parts of
the oven.
they are free of debris so that they stick properly to the
door and do not allow heat to disperse.
be obstructed.
may be hot.
Maintenance and care
oven or when removing it.
Switching the appliance off
Disconnect your appliance from the electricity supply before
carrying out any work on it.
” position
when the appliance is not in use.
Cleaning the appliance
the rubber seals may be cleaned using a sponge that
has been soaked in lukewarm water and neutral soap.
having disconnected the appliance from the electricity mains.
Use specialised products for the removal of stubborn
stains. After cleaning, rinse and dry thoroughly. Do not
should you attempt to perform the repairs yourself.
use abrasive powders or corrosive substances.
each use, while it is still lukewarm. Use hot water and
detergent, then rinse well and dry with a soft cloth. Do
not use abrasive products.
capacities, by inexperienced individuals or by anyone
- can be washed like everyday crockery, and are even
who is not familiar with the product. These individuals
dishwasher safe.
should, at the very least, be supervised by someone who
assumes responsibility for their safety or receive preliminary
! Never use steam cleaners or pressure cleaners on the
instructions relating to the operation of the appliance.
appliance.
21

Cleaning the oven door
GB
Clean the glass part of the oven door using a sponge and
a non-abrasive cleaning product, then dry thoroughly with
a soft cloth. Do not use rough abrasive material or sharp
metal scrapers as these could scratch the surface and cause
the glass to crack.
For more thorough cleaning purposes, the oven door may
be removed:
2. Lift up and turn the small levers
3. Grip the door on the two external
sides and close it approximately
half way. Pull the door towards you,
To replace the door, reverse this sequence.
Inspecting the seals
Check the door seals around the oven regularly. If the seals
are damaged, please contact your nearest Service Centre
until the seals have been replaced.
Replacing the light bulb
To replace the oven light
bulb:
1. Remove the glass cover
of the lamp-holder.
2. Remove the light bulb and
replace it with a similar one:
Wattage 25 W, cap E 14.
3. Replace the glass cover
see diagram
!
22