Pioneer VSX-920-K: The Advanced MCACC menu 10

The Advanced MCACC menu 10

6 Wait for the Auto MCACC Setup to finish

•If Reverse Phase is displayed, the

English

outputting test tones.

speaker’s wiring (+ and –) may be

3

A progress report is displayed on-screen while

inverted. Check the speaker connections.

the receiver outputs test tones to determine the

– If the connections were wrong, turn off

speakers present in your setup. Try to be as

the power, disconnect the power cord,

1

quiet as possible while it’s doing this.

then reconnect properly. After this,

Deutsch

• With error messages (such as Too much

perform the Full Auto MCACC procedure

ambient noise! or Check microphone)

again.

select RETRY after checking for ambient

– If the connections were right, select GO

noise (see Problems when using the Auto

NEXT and

continue.

MCACC Setup on page 42) and verifying the

8 Make sure ‘

OK

’ is selected, then press

mic connection. If there doesn’t seem to be

2

ENTER

.

Français

a problem, you can simply select GO NEXT

A progress report is displayed on-screen while

and continue.

the receiver outputs more test tones to

7 If necessary, confirm the speaker

determine the optimum receiver settings for

2

configuration in the GUI screen.

channel level, speaker distance, and Acoustic

The configuration shown on-screen should

Calibration EQ.

Italiano

reflect the actual speakers you have.

Again, try to be as quiet as possible while this

If no operations are performed for 10 seconds

is happening. It may take 3 to 7 minutes.

while the speaker configuration check screen

• If you selected a STAND.WAVE Multi-P

is being displayed, the Auto MCACC Setup will

setup (in step 2), you will be asked to place

resume automatically. In this case, you don’t

the mic at the 2nd and 3rd reference

Nederlands

need to select ‘OK’ and press ENTER in step 8.

points before finally placing it at your main

• If you see an ERR message (or the speaker

listening position.

configuration displayed isn’t correct), there

9 The Auto MCACC Setup procedure is

may be a problem with the speaker

completed and the

Advanced MCACC

menu

connection.

reappears automatically.

If selecting RETRY doesn’t work, turn off

Español

The settings made in the Auto MCACC Setup

the power and check the speaker

should give you excellent surround sound

connections. If there doesn’t seem to be a

from your system, but it is also possible to

problem, you can simply use / to select

adjust these settings manually using the

the speaker and / to change the

Manual MCACC setup menu (starting below)

setting and continue.

or Manual SP Setup menu (starting on

4

page 100).

89

En

VSX-1020_SYXCN.book 89 ページ ２０１０年３月１２日　金曜日　午前９時１０分

1 Do not adjust the volume during the test tones. This may result in incorrect speaker settings.

2 This screen is only shown if you selected ALL or Speaker Setting from the Auto MCACC menu.

3 If the speaker is not pointed to the microphone (listening position) or when using speakers that affect the phase

(dipole speakers, reflective speakers, etc.), Reverse Phase may be displayed even if the speakers are properly

connected.

4 • Depending on the characteristics of your room, sometimes identical speakers with cone sizes of around 12 cm will

end up with different size settings. You can correct the setting manually using the Manual speaker setup on page 100.

• The subwoofer distance setting may be farther than the actual distance from the listening position. This setting

should be accurate (taking delay and room characteristics into account) and generally does not need to be changed.

• If Auto MCACC Setup measurement results are incorrect due to the interaction of the speakers and viewing

environment, we recommend adjusting the settings manually.