Pioneer VSX-920-K: Chapter 9: Controlling the rest of your system Operating multiple receivers Setting the remote to control other components

Controlling the rest of your system 09

Chapter 9:

English

Controlling the rest of your

system

Deutsch

However, there are cases where only certain

Operating multiple receivers

functions may be controllable after assigning

the proper preset code, or the codes for the

Up to four receivers can be operated discretely

manufacturer in the remote control will not

using this receiver’s remote control when

Français

work for the model that you are using.

using multiple receivers, provided they are of

the same model as this receiver. The receiver to

If you can’t find a preset code that matches the

be operated is switched by inputting the preset

component you want to control, you can still

code to set the remote control setting.

teach the remote individual commands from

another remote control (see

Programming

• Set the remote modes on the receivers

Italiano

signals from other remote controls

on page 78).

before using this function (see Remote

Control Mode Setup on page 107).

Note

1 Press and hold

R.SETUP

, then press “4”

for three seconds.

• You can cancel or exit any of the steps by

The LED flashes continuously.

pressing R.SETUP.

Nederlands

• To cancel the preset setup mode press

• After one minute of inactivity, the remote

R.SETUP.

automatically exits the operation.

• For greater convenience, assign the TV

2 Press the number button for the receiver

connected to the MONITOR OUT terminal

(“

Receiver 1

” to “

Receiver 4

”) you wish to

to the TV CTRL button, and assign your

operate.

Español

satellite/cable receiver or set-top box

For example, to operate “Receiver 2”, press “2”.

connected to the TV input terminal to the

If the LED lights for one second, the setting has

TV input button. If a single device is

been successfully completed.

connected to both terminals, that device

When the preset code is input, the LED flashes

should be assigned to both the TV CTRL

three times to indicate that the setting has

and TV input buttons.

failed.

• Devices may be assigned to the following

input function buttons.

Setting the remote to control

other components

Most components can be assigned to one of

the input function buttons (such as DVD or

CD) using the component’s manufacturer

preset code stored in the remote.

77

En

VSX-1020_SYXCN.book 77 ページ ２０１０年３月１２日　金曜日　午前９時１０分