Pioneer VSX-920-K: Network Setup menu IP address/Proxy setting

The System Setup and Other Setup menus11

1 Select ‘

Speaker Distance

’ from the

Manual SP Setup

menu.

Network Setup menu

Set up the network to listen to Internet radio on

2 Adjust the distance of each speaker using

this receiver.

/

.

You can adjust the distance of each speaker in

1 Press on the remote control,

0.01 m increments.

then press

HOME MENU

.

3 When you’re finished, press

RETURN

.

A Graphical User Interface (GUI) screen

You will return to the Manual SP Setup menu.

appears on your TV. Use /// and

ENTER to navigate through the screens and

select menu items. Press RETURN to confirm

Tip

and exit the current menu.

• For best surround sound, make sure the

2Select ‘

System Setup

’ from the

Home

surround back speakers are the same

Menu

.

distance from the listening position.

3Select ‘

Network Setup

’ from the

System

X-Curve

Setup

menu.

Most soundtracks mixed for cinema sound too

4 Select the setting you want to adjust.

bright when played back in large rooms. The X-

If you are doing this for the first time, you may

Curve setting acts as a kind of re-equalization

want to adjust these settings in order:

for home theater listening, and restores proper

1

• IP Address, Proxy – Sets up the IP

tonal balance of movie soundtracks.

address/Proxy of this receiver (see below).

1 Select ‘

X-Curve

’ from the

Manual SP

• Information – Checks the MAC address of

Setup

menu.

this receiver (page 105).

2 Choose the X-Curve setting you want.

Use / to adjust the setting. The X-Curve is

IP address/Proxy setting

expressed as a downwards slope in decibels

In case the router connected to the LAN

per octave, starting at 2 kHz. The sound

terminal on this receiver is a broadband router

becomes less bright as the slope increases (to

(with a built-in DHCP server function), simply

a maximum of –3.0dB/oct). Use the following

turn on the DHCP server function, and you will

guidelines to set the X-Curve according to your

not need to set up the network manually. You

room size:

must set up the network as described below

only when you have connected this receiver to

a broadband router without a DHCP server

function. Before you set up the network,

consult with your ISP or the network manager

•If you select OFF, the frequency curve will

for the required settings. It is advised that you

be flat and the X-Curve has no effect.

also refer to the operation manual supplied

2

with your network component.

3 When you’re finished, press

RETURN

.

104

En

2

Room size (m

)

≤36 ≤48 ≤60 ≤72 ≤300 ≤1000

X-Curve

–0.5 –1.0 –1.5 –2.0 –2.5 –3.0

(dB/oct)

1 Since the principal is the same, X-Curve isn’t applied when you’re using the Pure direct mode.

2 In case you make changes to the network configuration without the DHCP server function, make the corresponding

changes to the network settings of this receiver.

VSX-1020_SYXCN.book 104 ページ ２０１０年３月１２日　金曜日　午前９時１０分