Indesit dsr 15b3: Care and maintenance

Care and maintenance

Shutting off the water and electricity supplies

Cleaning the filters

EN

• Turn off the water tap after every wash cycle to avoid leaks.

The filter assembly consists of three filters which remove food

residues from the washing water and then recirculate the water.

• Always unplug the appliance when cleaning it and when

They must be cleaned if you wish to achieve the best results in

performing maintenance work.

every wash.

Cleaning the dishwasher

Clean the filters regularly.

• The external surfaces of the machine and the control panel

The dishwasher must not be used without filters or if the filter

can be cleaned using a non-abrasive cloth which has been

is loose.

dampened with water. Do not use solvents or abrasive

products.

• After several washes, check the filter assembly and if necessary

clean it thoroughly under running water, using a non-metallic

• Any marks on the inside of the appliance may be removed

brush and following the instructions below:

using a cloth dampened with water and a little vinegar.

1. Turn the cylindrical filter C in an anti-clockwise direction and

pull it out

(fig. 1).

Preventing unpleasant odours

2. Remove the cup filter B by exerting a slight pressure on the

• Always keep the door of the appliance ajar in order to avoid

side flaps

(fig. 2);

moisture from forming and being trapped inside the machine.

3. Slide out the stainless-steel plate filter A.

(fig. 3).

• Clean the seals around the door and detergent dispensers

4. Inspect the trap and remove any food residues. NEVER

regularly using a damp sponge. This will avoid food becoming

REMOVE the wash-cycle pump protection

(black detail) (fig.4).

trapped in the seals, which is the main cause behind the

formation of unpleasant odours.

Cleaning the spray arms

Food residue may become encrusted onto the spray arms

and block the holes used to spray the water. It is therefore

recommended that you check the arms from time to time and

C

clean them with a small non-metallic brush.

The two spray arms may both be removed.

1

To remove the upper spray arm,

turn the plastic locking ring in an

anti-clockwise direction. The upper

spray arm should be replaced so

that the side with the greater number

of holes is facing upwards.

A

3

The lower spray arm can be removed

by pressing on the side tabs and

pulling it upwards.

After cleaning the filters, re-place the filter assembly and fix it in

position correctly; this is essential for maintaining the efficient

operation of the dishwasher.

Leaving the machine unused for extended

periods

• Disconnect the appliance from the electricity supply and shut

Cleaning the water inlet hose*

off the water tap.

If the water hoses are new or have not been used for an extended

period of time, let the water run to make sure it is clear and free

• Leave the door of the appliance ajar.

of impurities before performing the necessary connections. If this

precaution is not taken, the water inlet could become blocked

• When you return, run a wash cycle when the dishwasher is

and damage the dishwasher.

empty.

Clean the water inlet filter at the tap outlet regularly.

- Turn off the water tap.

- Unscrew the end of the water inlet hose, remove the filter and

clean it carefully under running water.

- Re-place the filter and screw the water hose back into position.

* Only available in selected models.

15