Pioneer VSX-421: Connecting your equipment

Connecting your equipment

7

En

Connecting your equipment

Hints on the speaker placement

Where you put your speakers in the room has a big effect on the quality of the sound. The

following guidelines should help you to get the best sound from your system.

Placing the speakers

• The subwoofer can be placed on the floor. Ideally, the other speakers should be at about

By connecting the left and right front speakers (

L

/

R

), the center speaker (

C

), the left and right

ear-level when you’re listening to them. Putting the speakers on the floor (except the

surround speakers (

SL

/

SR

), and the subwoofer (

SW

), a 5.1 ch surround system can be enjoyed.

subwoofer), or mounting them very high on a wall is not recommended.

Further, by using an external amplifier, you can connect the left and right surround back

• For the best stereo effect, place the front speakers 2 m to 3 m apart, at equal distance from

speakers (SBL/SBR) to boost your system up to a 7.1 ch surround system.

the TV.

• You can also connect one surround back speaker (SB) and enjoy a 6.1 ch surround system.

• If you’re going to place speakers around your CRT TV, use shielded speakers or place the

speakers at a sufficient distance from your CRT TV.

To achieve the best possible surround sound, install your speakers as shown below.

• If you’re using a center speaker, place the front speakers at a wider angle. If not, place

them at a narrower angle.

• Place the center speaker above or below the TV so that the sound of the center channel is

localized at the TV screen. Also, make sure the center speaker does not cross the line

formed by the leading edge of the front left and right speakers.

• It is best to angle the speakers towards the listening position. The angle depends on the

size of the room. Use less of an angle for bigger rooms.

• Surround and surround back speakers should be positioned 60 cm to 90 cm higher than

your ears and titled slight downward. Make sure the speakers don’t face each other. For

DVD-Audio, the speakers should be more directly behind the listener than for home

theater playback.

• If the surround speakers cannot be set directly to the side of the listening position with a

7.1-channel system, the surround effect can be enhanced by turning off the Up Mix

function (see Setting the Up Mix function on Operating Instructions in CD-ROM).

• Try not to place the surround speakers farther away from the listening position than the

front and center speakers. Doing so can weaken the surround sound effect.

a. This layout is available only when the additional amplifier is connected to the unit and the

surround back speakers are connected to the amplifier. For details, see Connect the surround back

speakers on page 8.

• Make sure that all speakers are securely installed. This not only improves sound quality,

but also reduces the risk of damage or injury resulting from speakers being knocked over

or falling in the event of external shocks such as earthquakes.

• To connect the surround back speakers, an additional amplifier is required. Connect the

additional amplifier to the PRE OUT SURR BACK outputs of this unit and connect the

surround back speakers to the additional amplifier (see Connect the surround back

speakers on page 8).

VSX-421_SYXCN_QSG_En.book 7 ページ ２０１１年３月７日　月曜日　午後４時２５分