Pioneer CDJ-2000NXS: POWER-CORD CAUTION

3

En

POWER-CORD CAUTION

Handle the power cord by the plug. Do not pull out the 

plug by tugging the cord and never touch the power 

cord when your hands are wet as this could cause a 

short circuit or electric shock. Do not place the unit, a 

piece of furniture, etc., on the power cord, or pinch the 

cord. Never make a knot in the cord or tie it with other 

cords. The power cords should be routed such that they 

are not likely to be stepped on. A damaged power cord 

can cause a fire or give you an electrical shock. Check 

the power cord once in a while. When you find it 

damaged, ask your nearest PIONEER authorized 

service center or your dealer for a replacement.

S002*_A1_En

CAUTION

This product is a class 1 laser product classified 

under the Safety of laser products, IEC 60825-1:2007.

CLASS 1 LASER PRODUCT

D58-5-2-2a_A1_En

Before making or changing the connections, 

switch off the power and disconnect the power 

cord from the AC outlet.

D44-9-3_A1_En

Condensation

Water droplets (condensation) may form inside the unit 

(on operating parts and lenses) in the winter, for 

example, if the unit is moved from a cold place into a 

warm room or if the temperature in the room in which 

the unit is installed rises suddenly (through heating, 

etc.). The unit will not operate properly and will not be 

playable with condensation inside. Let the unit stand for 

1 to 2 hours at room temperature (though this time 

depends on the conditions of the condensation) without 

turning on the power. The water droplets will evaporate 

and the unit will become playable. Condensation can 

occur in the summer as well if the unit is exposed to the 

direct wind from an air-conditioner, etc. If this happens, 

move the unit to a different location.

S005_A1_En

CAUTION

The 

POWER

 switch on this unit will not completely 

shut off all power from the AC outlet. Since the power 

cord serves as the main disconnect device for the 

unit, you will need to unplug it from the AC outlet to 

shut down all power. Therefore, make sure the unit 

has been installed so that the power cord can be 

easily unplugged from the AC outlet in case of an 

accident. To avoid fire hazard, the power cord should 

also be unplugged from the AC outlet when left 

unused for a long period of time (for example, when 

on vacation).

D3-4-2-2-2a*_A1_En

VENTILATION CAUTION

When installing this unit, make sure to leave space 

around the unit for ventilation to improve heat radiation 

(at least 5 cm at rear, and 5 cm at each side).

WARNING

Slots and openings in the cabinet are provided for 

ventilation to ensure reliable operation of the product, 

and to protect it from overheating. To prevent fire 

hazard, the openings should never be blocked or 

covered with items (such as newspapers, table-cloths, 

curtains) or by operating the equipment on thick carpet 

or a bed.

D3-4-2-1-7b*_A1_En

When using this product, confirm the safety 

information shown on the bottom of the unit.

D3-4-2-2-4_B1_En