Pioneer XC-HM70-K: VENTILATION CAUTION IMPORTANT Operating Environment

VENTILATION CAUTION

IMPORTANT

When installing this unit, make sure to leave space

around the unit for ventilation to improve heat radiation

CAUTION

(at least 10 cm at top, 10 cm at rear, and 10 cm at each

RISK OF ELECTRIC SHOCK

side).

DO NOT OPEN

The lightning flash with arrowhead symbol,

CAUTION:

The exclamation point within an equilateral

within an equilateral triangle, is intended to

TO PREVENT THE RISK OF ELECTRIC

triangle is intended to alert the user to the

10 cm 10 cm

alert the user to the presence of uninsulated

SHOCK, DO NOT REMOVE COVER (OR

presence of important operating and

“dangerous voltage” within the product’s

BACK). NO USER-SERVICEABLE PARTS

maintenance (servicing) instructions in the

10 cm

enclosure that may be of sufficient

INSIDE. REFER SERVICING TO QUALIFIED

literature accompanying the appliance.

magnitude to constitute a risk of electric

SERVICE PERSONNEL.

TIMER

shock to persons.

D3-4-2-1-1_A1_En

10 cm

WARNING

Operating Environment

WARNING

This equipment is not waterproof. To prevent a fire or

Operating environment temperature and humidity:

Slots and openings in the cabinet are provided for

shock hazard, do not place any container filled with liquid

+5 °C to +35 °C (+41 °F to +95 °F); less than 85 %RH

ventilation to ensure reliable operation of the product,

near this equipment (such as a vase or flower pot) or

(cooling vents not blocked)

and to protect it from overheating. To prevent fire

expose it to dripping, splashing, rain or moisture.

Do not install this unit in a poorly ventilated area, or in

hazard, the openings should never be blocked or

D3-4-2-1-3_A1_En

locations exposed to high humidity or direct sunlight (or

covered with items (such as newspapers, table-cloths,

strong artificial light)

curtains) or by operating the equipment on thick carpet

D3-4-2-1-7c*_A1_En

or a bed.

D3-4-2-1-7b*_A1_En

WARNING

Before plugging in for the first time, read the following

If the AC plug of this unit does not match the AC

CAUTION

section carefully.

outlet you want to use, the plug must be removed

The STANDBY/ON switch on this unit will not

The voltage of the available power supply differs

and appropriate one fitted. Replacement and

completely shut off all power from the AC outlet.

according to country or region. Be sure that the

mounting of an AC plug on the power supply cord of

Since the power cord serves as the main disconnect

power supply voltage of the area where this unit

this unit should be performed only by qualified

device for the unit, you will need to unplug it from the

will be used meets the required voltage (e.g., 230 V

service personnel. If connected to an AC outlet, the

AC outlet to shut down all power. Therefore, make

or 120 V) written on the rear panel.

D3-4-2-1-4*_A1_En

cut-off plug can cause severe electrical shock. Make

sure the unit has been installed so that the power

sure it is properly disposed of after removal.

cord can be easily unplugged from the AC outlet in

The equipment should be disconnected by removing

case of an accident. To avoid fire hazard, the power

the mains plug from the wall socket when left unused

cord should also be unplugged from the AC outlet

WARNING

for a long period of time (for example, when on

when left unused for a long period of time (for

To prevent a fire hazard, do not place any naked flame

vacation).

example, when on vacation).

sources (such as a lighted candle) on the equipment.

D3-4-2-2-1a_A1_En

D3-4-2-2-2a*_A1_En

D3-4-2-1-7a_A1_En