Pioneer S-LX70W: TROUBLESHOOTING SYMPTOM CAUSE REMEDY SPECIFICATIONS

TROUBLESHOOTING SYMPTOM CAUSE REMEDY SPECIFICATIONS: Pioneer S-LX70W

01_S_LX70W_En.book 8 ページ 2008年7月18日 金曜日 午後5時4分

TROUBLESHOOTING

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with

this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other

components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks

listed below, ask your nearest PIONEER authorized service center or your dealer to carry out repair work.

SYMPTOM

CAUSE REMEDY

1 No power is being supplied

Power supply plug is not

Insert plug securely.

(Indicator does not light up

correctly inserted.

when power switch is turned

on.)

2 No sound

Connection of accessory RCA

Check again and connect correctly.

(Indicator is lit.)

plug cord is wrong or

disconnected.

VOLUME

knob is set to

MIN

.

Turn clockwise slowly.

3 Sound is distorted.

Level is too high.

Turn the

VOLUME

knob counter-

clockwise to lower the level.

Input level is too high.

Turn the amplifier’s output level (volume,

bass control, bass boost) counter-

clockwise to lower the level.

4 Howling noise occurs.

No power supplied to the

Connect an amplifier and supply power.

amplifier.

Subwoofer level is set too high.

Place the subwoofer a good distance

from speakers. Turn the

VOLUME

knob

counter-clockwise to lower the volume.

5 Much noise when listening to

The AM loop antenna or the FM

Increase the distance between the AM or

AM or FM broadcasts.

indoor antenna is close to this

FM antenna (for indoor use) and this unit.

unit.

SPECIFICATIONS

Cabinet ....................... Floor type with CLOSED BOX system

(magnetically shielded)

Speaker........................................................... 30 cm cone type

Frequency response

Published by Pioneer Corporation.

.....................................25 Hz to 4000 Hz (set to BYPASS ON)

Copyright © 2007 Pioneer Corporation.

Power Amplifier Continuous Power Output (RMS)

All rights reserved.

................................................................... 300 W/4

(100 Hz)

Input (sensitivity at 100 Hz/impedance)

LINE LEVEL (RCA jack)................................... 160 mV/33 k

Output (Level at 100 Hz/impedance)

is a trademark placed on a product with

LINE LEVEL (RCA jack)...................................... 160 mV/1 k

Pioneer’s Phase Control Technology.

Selectable CROSSOVER Frequencies

The Technology enables high-grade 5.1ch with no delay

.......................................................50 Hz, 60 Hz, 70 Hz, 80 Hz,

in the bass area.

100 Hz, 120 Hz, 160 Hz, 200 Hz

Outline Dimension

........................... 362 mm (W) x 365 mm (H) x 362 mm (D)

Weight (without package).............................................18.2 kg

Power Requirements................220 V to 230 V~, 50

Hz/60

Hz

Power Consumption......................................................... 90 W

Power Consumption in standby..................................... 1.0 W

Accessories............................................... RCA plug cord x 1

Power cable x 1

Polishing cloth x 1

Warranty card x 1

Operating instructions

Specifications and design subject to possible

modification without notice, due to improvements.

8

En