Pioneer S-LX70W: IMPORTANT

01_S_LX70W_En.book 2 ページ ２００８年７月１８日　金曜日　午後５時４分

IMPORTANT

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

The lightning flash with arrowhead symbol,

CAUTION:

The exclamation point within an equilateral

within an equilateral triangle, is intended to

TO PREVENT THE RISK OF ELECTRIC

triangle is intended to alert the user to the

alert the user to the presence of uninsulated

SHOCK, DO NOT REMOVE COVER (OR

presence of important operating and

"dangerous voltage" within the product's

BACK). NO USER-SERVICEABLE PARTS

maintenance (servicing) instructions in the

enclosure that may be of sufficient

INSIDE. REFER SERVICING TO QUALIFIED

literature accompanying the appliance.

magnitude to constitute a risk of electric

SERVICE PERSONNEL.

shock to persons.

D3-4-2-1-1_En-A

This product complies with the Low Voltage Directive

WARNING

2006/95/EC and EMC Directive 2004/108/EC.

To prevent a fire hazard, do not place any naked

D3-4-2-1-9a_A_En

flame sources (such as a lighted candle) on the

equipment.

D3-4-2-1-7a_A_En

Thank you for buying this PIONEER product. Please read

VENTILATION CAUTION

through these operating instructions so you will know

When installing this unit, make sure to leave space

how to operate your model properly. After you have

around the unit for ventilation to improve heat

finished reading the instructions, put them away in a safe

radiation (at least 25 cm at top, 15 cm at rear, and

place for future reference.

10 cm at each side).

In some countries or regions, the shape of the power

WARNING

plug and power outlet may sometimes differ from that

Slots and openings in the cabinet are provided for

shown in the explanatory drawings. However, the

ventilation to ensure reliable operation of the

method of connecting and operating the unit is the same.

product, and to protect it from overheating. To

prevent fire hazard, the openings should never be

WARNING

blocked or covered with items (such as newspapers,

This equipment is not waterproof. To prevent a fire

table-cloths, curtains) or by operating the

or shock hazard, do not place any container filled

equipment on thick carpet or a bed.

D3-4-2-1-7b_A_En

with liquid near this equipment (such as a vase or

flower pot) or expose it to dripping, splashing, rain

or moisture.

D3-4-2-1-3_A_En

[For U.K. model]

Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified

service personnel.

IMPORTANT: THE MOULDED PLUG

This appliance is supplied with a moulded three pin mains plug for your safety and convenience. A 10 amp fuse is fitted in this plug. Should

the fuse need to be replaced, please ensure that the replacement fuse has a rating of 10 amps and that it is approved by ASTA or BSI to

BS1362.

Check for the ASTA mark or the BSI mark on the body of the fuse.

If the plug contains a removable fuse cover, you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug

must not be used until a replacement cover is obtained. A replacement fuse cover can be obtained from your local dealer.

If the fitted moulded plug is unsuitable for your socket outlet, then the fuse shall be removed and the plug cut off and disposed of

safely. There is a danger of severe electrical shock if the cut off plug is inserted into any 13 amp socket.

If a new plug is to be fitted, please observe the wiring code as shown below. If in any doubt, please consult a qualified electrician.

IMPORTANT: The wires in this mains lead are coloured in accordance with the following code:

Blue : Neutral Brown : Live

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in

your plug, proceed as follows ;

The wire which is coloured BLUE must be connected to the terminal which is marked with the

letter N or coloured BLACK.

The wire which is coloured BROWN must be connected to the terminal which is marked with the

letter L or coloured RED.

How to replace the fuse: Open the fuse compartment with a screwdriver and replace the fuse.

D3-4-2-1-2-2_B_En