Pioneer S-LX70W: Operating Environment POWER-CORD CAUTION

Operating Environment POWER-CORD CAUTION: Pioneer S-LX70W

01_S_LX70W_En.book 3 ページ 2008年7月18日 金曜日 午後5時4分

If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used

electronic products in accordance with legislation that requires proper treatment, recovery and recycling.

Private households in the member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to

designated collection facilities or to a retailer (if you purchase a similar new one).

For countries not mentioned above, please contact your local authorities for the correct method of disposal.

By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential

negative effects on the environment and human health.

K058_A_En

WARNING

If the AC plug of this unit does not match the AC

Before plugging in for the first time, read the following

outlet you want to use, the plug must be removed

section carefully.

and appropriate one fitted. Replacement and

The voltage of the available power supply differs

mounting of an AC plug on the power supply cord of

according to country or region. Be sure that the

this unit should be performed only by qualified

power supply voltage of the area where this unit

service personnel. If connected to an AC outlet, the

will be used meets the required voltage (e.g., 230 V

cut-off plug can cause severe electrical shock. Make

or 120 V) written on the rear panel.

D3-4-2-1-4_A_En

sure it is properly disposed of after removal.

The equipment should be disconnected by removing

the mains plug from the wall socket when left

WARNING:

unused for a long period of time (for example, when

Do not climb or sit on this unit. Be especially

on vacation).

D3-4-2-2-1a_A_En

careful when children are around. The unit may be

damaged, or may fall over causing injury.

CAUTION

The POWER switch on this unit will not completely

Operating Environment

shut off all power from the AC outlet. Since the

Operating environment temperature and humidity:

power cord serves as the main disconnect device for

+5 ºC to +35 ºC (+41 ºF to +95 ºF); less than 85 %RH

the unit, you will need to unplug it from the AC outlet

(cooling vents not blocked)

to shut down all power. Therefore, make sure the

Do not install this unit in a poorly ventilated area, or in

unit has been installed so that the power cord can

locations exposed to high humidity or direct sunlight (or

be easily unplugged from the AC outlet in case of an

strong artificial light).

D3-4-2-1-7c_A_En

accident. To avoid fire hazard, the power cord should

also be unplugged from the AC outlet when left

unused for a long period of time (for example, when

POWER-CORD CAUTION

on vacation).

D3-4-2-2-2a_A_En

Handle the power cord by the plug. Do not pull out the

plug by tugging the cord and never touch the power

cord when your hands are wet as this could cause a

short circuit or electric shock. Do not place the unit, a

piece of furniture, etc., on the power cord, or pinch the

cord. Never make a knot in the cord or tie it with other

cords. The power cords should be routed such that they

are not likely to be stepped on. A damaged power cord

can cause a fire or give you an electrical shock. Check

the power cord once in a while. When you find it

damaged, ask your nearest PIONEER authorized

service center or your dealer for a replacement.

S002_En