Pioneer S-HS100: Wall-mounting the front and surround speaker system Attaching the brackets Before mounting Operation
Wall-mounting the front and surround speaker system Attaching the brackets Before mounting Operation: Pioneer S-HS100
Table of contents
- IMPORTANT Operating Environment VENTILATION CAUTION
- IMPORTANT: THE MOULDED PLUG
- POWER-CORD CAUTION
- Installation Speaker installation Features Accessory Items
- Installation precautions
- Effective Combination of Subwoofer and Satellite Speakers Connections and Use Panel facilities Front panel Affixing Non-Skid Pads
- Rear panel Connection Line level connection
- Connections and Use Connecting the power cord Connection Connecting the speakers Operation
- Wall-mounting the front and surround speaker system Attaching the brackets Before mounting Operation
- Specifications
- Troubleshooting Symptom Cause Remedy
- Symptom Cause Remedy

English Français Deutsch
Wall-mounting the front
• These speaker terminals carry
and surround speaker
HAZARDOUS LIVE voltage. To prevent the
system
risk of electric shock when connecting or
disconnecting the speaker cords,
Attaching the brackets
disconnect the power cord before touching
• When attaching the speakers to brackets,
any uninsulated parts.
always use the furnished brackets for wall
• After connecting the plugs, pull lightly on
mounting.
the cords to make sure that the ends of the
• Make sure to tighten the supplied screw as
cords are securely connected to the
securely as possible when attaching the
terminals. Poor connections can create
bracket to the back of the speaker.
noise and interruptions in the sound.
• Do not attach brackets to center speaker or
• If the cords’ wires happen to be pushed out
subwoofer.
of the terminals, allowing the wires to come
into contact with each other, it places an
excessive additional load on the receiver.
This may cause the amp to stop
• Use the M5 metric thread screw. Do not
functioning, and may even damage the
use inch thread screw.
receiver.
Italiano Español
Before mounting
• When using a set of speakers connected to
an receiver, you won’t be able to obtain the
• Remember that the speaker system is
normal stereo effect if the polarity (+, –) of
heavy and that its weight could cause the
one of the speakers (left or right) is
wood screws to work loose, or the wall
reversed.
material to fail to support it, resulting in the
Nederlands
speaker falling. Make sure that the wall on
which you intend to mount the speakers is
Operation
strong enough to support them. Do not
• Set the receiver’s cross-over frequency
mount on plywood or soft surface walls.
at 200 Hz.
• Mounting screws are not supplied. Use
screws suitable for the wall material and
support the weight of the speaker. If you are
unsure of the qualities and strength of the
walls, consult a professional for advice.
Pyccкий
Screw (supplied)
11
En
5 mm
(3/16 in.)
5 mm (3/16 in.) to 7 mm (9/32 in.)
10 mm
Mounting screw (not supplied)
(13/32 in.)
01_S-21W&S-11.book 11 ページ 2010年3月16日 火曜日 午前11時28分

