Pioneer S-HS100: IMPORTANT: THE MOULDED PLUG

For U.K. model and Singapore model only

Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified

service personnel.

IMPORTANT: THE MOULDED PLUG

This appliance is supplied with a moulded three pin mains plug for your safety and convenience. A 5 amp fuse is fitted in this plug.

Should the fuse need to be replaced, please ensure that the replacement fuse has a rating of 5 amps and that it is approved by ASTA or BSI to

BS1362.

Check for the ASTA mark or the BSI mark on the body of the fuse.

If the plug contains a removable fuse cover, you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug

must not be used until a replacement cover is obtained. A replacement fuse cover can be obtained from your local dealer.

If the fitted moulded plug is unsuitable for your socket outlet, then the fuse shall be removed and the plug cut off and disposed of

safely. There is a danger of severe electrical shock if the cut off plug is inserted into any 13 amp socket.

If a new plug is to be fitted, please observe the wiring code as shown below. If in any doubt, please consult a qualified electrician

.

IMPORTANT: The wires in this mains lead are coloured in accordance with the following code:

Blue : Neutral Brown : Live

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in

your plug, proceed as follows;

The wire which is coloured BLUE must be connected to the terminal which is marked with the

letter N or coloured BLACK.

The wire which is coloured BROWN must be connected to the terminal which is marked with the

letter L or coloured RED.

How to replace the fuse: Open the fuse compartment with a screwdriver and replace the fuse.

D3-4-2-1-2-2*_A2_En

1)

Read these instructions.

11)

Only use attachments/accessories specified by

2)

Keep these instructions.

the manufacturer.

3)

Heed all warnings.

12)

Use only with the ca

rt, stand, tripod, bracket, or

4)

Follow all instructions.

table specified by the manufacturer, or sold with

5)

Do not use this apparatus near water.

the apparatus. When a cart is used, use caution

6)

Clean only with dry cloth.

when moving the cart/apparatus combination to

7)

Do not block any ventilation openings. Install in

avoid injury from tip-o

ver.

accordance with the manufacturer’s

instructions.

8)

Do not install near any heat sources such as

radiators, heat registers, stoves, or other

apparatus (including amplifiers) that produce

heat.

9)

Do not defeat the safety purpose of the polarized

or grounding-type plug. A polarized plug has two

13)

Unplug this apparatus during lightning storms

blades with one wider than the other. A

or when unused for long periods of time.

grounding type plug has two blades and a third

14)

Refer all servicing to qualified service personnel.

grounding prong. The wide blade or the third

Servicing is required when the apparatus has

prong are provided for your safety

. If the provided

been damaged in any way, such as power-supply

plug does not fit into your outlet, consult an

cord or plug is damaged, liquid has been spilled

electrician for replacement of the obsolete outlet.

or objects have fallen into the apparatus, the

10)

Protect the power cord from being walked on or

apparatus has been exposed to rain or moisture,

pinched particularly at plugs, convenience

does not operate normally

, or has been dropped.

receptacles, and the point where they exit from

the apparatus.

D3-7-13-69_En