Pioneer CP-LX70: Connect the speaker cable to the amplifier Placement Changing the Speaker Height

01_CP-LX70_EU.book 6 ページ ２００７年９月５日　水曜日　午前１０時５１分

Connect the speaker cable to the amplifier

Placement

Connect the speaker cable to the terminals located on the rear side

Finish the installation of the speaker systems in your room by

of the stand base.

standing them and their attached stands upright. Refer to the

section “When Installing the Speaker Stands” on page 3.

1 Switch off the power to your amplifier.

• The bottom and top cushioning materials should not be

2 Connect the speaker cables to the input terminals on the rear

discarded after assembly, but stored in a safe place.

side of the stand base. For input terminal polarity, red is positive

(+) and black is negative (–).

Changing the Speaker Height

When changing the height of the speakers, reassemble the stand

while referring to step 3 through 6 of “Assembling the Speaker

Stand.”

• Do not attempt to adjust the speaker height while the stand is

upright. This could cause the speaker to fall, resulting in

damage or personal injury.

3 Connect the other ends of the cables to the amp's speaker

output terminals (for more details, refer to your amp owner's

manual).

• Grasp the cap knobs on the lower input terminals and rotate

them to the left (counter-clockwise), insert the speaker cable

wires into the holes in the terminal posts, then tighten the

knobs to secure the wires.

• You can also connect the stand base’s terminals with a banana

plug. When using a banana plug, be sure to remove the cap at

the tip of the input terminal.

• If the cables’ wires happen to be pushed out of the terminals,

allowing the wires to come into contact with each other, it

places an excessive additional load on the amp. This may cause

the amp to stop functioning, and may even damage the amp.

• After connecting the plugs, pull lightly on the cables to make

sure that the ends of the cables are securely connected to the

terminals. Poor connections can create noise and interruptions

in the sound.

• When using a set of speakers connected to an amplifier, you

won't be able to obtain the normal stereo effect if the polarity

(+ , –) of one of the speakers (left or right) is reversed.

6

En