Pioneer CP-LX70: Assembling the speaker stands Installing the speaker stands

01_CP-LX70_EU.book 3 ページ ２００７年９月５日　水曜日　午前１０時５１分

English Français Deutsch

Assembling the speaker stands

The pillars and speaker stand bases are designed with specific

Make sure you assemble the stand on a flat surface that is relatively

directional orientation for assembly. During assembly, make sure

they are attached in the correct directions.

soft (such as a carpet).

A medium-sized Phillips screwdriver is required for assembly.

• The Styrofoam cushions are used during assembly.

Front side Rear side

CP-LX70 only: Confirm that the surfaces with printing are

facing upwards and oriented as shown, then align the top

cushion on the bottom cushion as illustrated.

Cushioning

material (Top)

Italiano Español Português Dansk Norsk SuomiSvenska

Installing the speaker stands

• Place the stand on a stable, level surface; placing the stand on

Nederlands

Cushioning

an unstable surface can be dangerous.

material (Bottom)

When placing the speaker, keep in mind that the tone is affected by

the position of the speaker.

1 Run the speaker cable through the pillar and place the pillar

If the bass is insufficient, move the speaker closer to the wall. The

onto the stand base.

richest bass sound is obtained when the speaker is right against

Place the pillar on a flat surface and cut the string that is strung

the wall. If the bass is too powerful, producing a muffled tone, move

through the pillar. Tie the speaker cable coming out of the stand

the speaker away from the wall. Placing the speaker against a thick

base to the end string at the bottom of the pillar. Pull the end of the

curtain may also be effective.

string emerging from the top front side of the pillar to pull the

Adjust the position as necessary to obtain optimal sound from your

speaker cable up through the pillar.

system.

• Remove the string once the speaker cable is through the pillar.

Next, stand the pillar upright and fit the bottom of the pillar into the

stand base, making sure that the pillar is aligned with the hole in

the stand base.

• When fitting the pillar into the stand base, make sure that the

speaker cable comes through the groove on the bottom of the

pillar and does not get pinched between the pillar and the stand

base.

• Make sure not to scratch the surface of the stand base with the

pillar, as the decorative laminate of the stand base may scar

easily.

3

En