Pioneer DEH-1600UBB: Troubleshooting Error messages

Black plate (10,1)

Section

03

Installation

Additional information

2 Mounting sleeve

! When reattaching the trim ring, point the

Symptoms are written in bold and causes in reg-

Troubleshooting

# Make sure that the unit is installed securely in

side with the notched tab down.

ular, non-indented text. Regular, indented text is

place. An unstable installation may cause skipping

Symptoms are written in bold and causes in reg-

used to indicate actions to be taken.

or other malfunctions.

2 Insert the supplied extraction keys into

ular, non-indented text. Regular, indented text is

both sides of the unit until they click into

used to indicate actions to be taken.

Common

place.

DIN Rear-mount

AMP ERROR

The display automatically returns to the ordinary

1 Determine the appropriate position

3 Pull the unit out of the dashboard.

display.

This unit fails to operate or the speaker connection is

where the holes on the bracket and the side

incorrect; the protective circuit is activated.

of the unit match.

You did not perform any operation within about 30

Check the speaker connection. If the message

seconds.

fails to disappear even after the engine is

Perform operation again.

switched off/on, contact your dealer or an

authorized Pioneer Service Station for

The repeat play range changes unexpectedly.

assistance.

Depending on the repeat play range, the selected

range may change when another folder or track is

2 Tighten two screws on each side.

Removing and re-attaching the front

being selected or during fast forwarding/reversing.

CD player

panel

Select the repeat play range again.

You can remove the front panel to protect your

ERROR-07, 11, 12, 17, 30

3

1

unit from theft.

A subfolder is not played back.

The disc is dirty.

For details, refer to Removing the front panel and

Subfolders cannot be played when FLD (folder re-

Clean the disc.

Re-attaching the front panel on page 4.

peat) is selected.

2

The disc is scratched.

Select another repeat play range.

Replace the disc.

1 Tapping screw (5 mm × 8 mm)

NO XXXX appears when a display is changed

2 Mounting bracket

ERROR-07, 10, 11, 12, 15, 17, 30, A0

(NO TITLE, for example).

3 Dashboard or console

There is an electrical or mechanical error.

There is no embedded text information.

Turn the ignition switch OFF and back ON, or

Switch the display or play another track/file.

switch to a different source, then back to the CD

Removing the unit

player.

1 Remove the trim ring.

The unit is malfunctioning.

There is interference.

ERROR-15

You are using a device, such as a cellular phone,

The inserted disc is blank.

that may cause audible interference.

Replace the disc.

Move electrical devices that may be causing the

interference away from the unit.

ERROR-23

Unsupported CD format.

Replace the disc.

1 Trim ring

Error messages

2 Notched tab

When you contact your dealer or your nearest

! Releasing the front panel allows easier ac-

Pioneer Service Center, be sure to note the error

cess to the trim ring.

message.

10

En

<QRD3204-A>10