Pioneer X-CM31-R: Chapter 4: Getting started To turn the power on General control Setting the clock

Getting started04

Chapter 4:

Getting started

To turn the power on

General control

Press the 1 STANDBY/ON to turn the power on.

After use:

Input function

Press the 1 STANDBY/ON to enter the power stand-by mode.

When the INPUT on main unit is pressed, the current function

will change to different mode. Press the INPUT repeatedly to

Note

select desired function.

• In standby mode, if iPod/iPhone/iPad is connected, the

unit turns charge mode.

Setting the clock

Display brightness control

Press DIMMER to dims the display brightness. The

brightness can be controlled in four steps.

Volume auto set-in

If you turn off and on the main unit with the volume set to 17

or higher, the volume starts at 16 and sets in to the last set

level.

1 Press

1 STANDBY/ON

to turn the power on.

Volume control

2 Press

CLOCK/TIMER

on the remote control.

Turn the volume knob towards VOLUME (on main unit) or

“CLOCK” is shown on the main display.

press VOLUME +/- (on remote control) to increase or

decrease the volume.

3 Press

ENTER

.

CAUTION

4 Press

HI

to set the day, then press ENTER.

• The sound level at a given volume setting depends on

5 Press

HI

to set the hour, then press

speaker efficiency, location, and various other factors. It

ENTER.

is advisable to avoid exposure to high volume levels. Do

not turn the volume on to full at switch on. Listen to

6 Press

HI

to set the minute, then press

music at moderate levels. Excessive sound pressure

ENTER to confirm.

from earphones and headphones can cause hearing

loss.

7 Press

ENTER

.

To confirm the time display:

Muting

Press the CLOCK/TIMER. The time display will appear for

The volume is muted temporarily when pressing the MUTE on

about 10 seconds.

the remote control. Press again to restore the volume.

To readjust the clock:

Perform “Setting the clock” from step 1.

Note

• When power supply is restored after unit is plugged in

again or after a power failure, reset the clock.

12

En

;&0B6<;(B(QERRN࣮࣌ࢪ㸰㸮㸯㸱ᖺ㸲᭶㸶᪥ࠉ᭶᭙᪥ࠉ༗๓㸯㸯󰪍㸲㸷ศ