Pioneer HTP-SLH500: Installation

S-SLW500

Installing the subwoofer

Installation

The subwoofer can be mounted in either vertical or horizontal ori-

entation. The factory default is horizontal orientation.

Mounting location

Installation example: For both S-HV600B and S-

SLW500

English

For vertical orientation installation

1 The feet are attached with Phillips screws; use a Phillips

screwdriver to remove them.

2 Apply the accessory seals to the place the feet were

located to hide the screw holes.

3 Apply the non-skid pads to the four corners of the surface

where the subwoofer is to be mounted. Note that the non-

skid pads may not be fully effective on all surfaces, so do not

install in slippery locations.

Installation example: For both S-HV500-LR and S-

SLW500

• Do not attempt to perform these procedures while tilting the

S-HV600B

unit at an angle. Lay the unit on its side on soft cloth or other

• Sounds played through speaker systems are easily affected in

material that will not scar the unit.

subtle ways by the conditions in the listening space.

• This speaker system does not feature a magnetically shielded

design. As a result, color distortion may occur if the speaker is

placed near a conventional CRT television. In this event, move

the speaker farther away from the television. In addition,

devices easily affected by magnetism (magnetic media cards,

wrist-watches, video tapes, etc.) should not be placed near

this speaker.

• If the room has a lot of reverberation, we recommend hanging

heavy fabric on the walls, and/or putting a carpet on the floor

to damp the sound. For best results, cover walls completely.

5

En

S-HV600B_S-HV500-LR_En.fm 5 ページ ２０１１年４月１２日　火曜日　午後２時３１分