Pioneer DEH-150MPG: Connections Using an AUX source

For details, refer to System menu on page 6.

— Never wire the negative speaker cable directly

Connections

to ground.

Important

— Never band together negative cables of multi-

Using an AUX source

! When installing this unit in a vehicle without

ple speakers.

an ACC (accessory) position on the ignition

! When this unit is on, control signals are sent

1 Insert the stereo mini plug into the AUX

switch, failure to connect the red cable to the

through the blue/white cable. Connect this

input jack.

terminal that detects operation of the ignition

cable to the system remote control of an ex-

key may result in battery drain.

ternal power amp or the vehicle’s auto-anten-

2 Press SRC/OFF to select AUX as the

na relay control terminal (max. 300 mA

source.

F

F

O

N

12 V DC). If the vehicle is equipped with a

O

S

Note

T

A

glass antenna, connect it to the antenna

T

R

AUX cannot be selected unless the auxiliary set-

booster power supply terminal.

ting is turned on. For more details, refer to AUX

! Never connect the blue/white cable to the

ACC position No ACC position

(auxiliary input) on the previous page.

power terminal of an external power amp.

! Use of this unit in conditions other than the

Also, never connect it to the power terminal

following could result in fire or malfunction.

of the auto antenna. Doing so may result in

Switching the display

— Vehicles with a 12-volt battery and negative

battery drain or a malfunction.

grounding.

! The black cable is ground. Ground cables for

Selecting the desired text information

— Speakers with 50 W (output value) and 4 W to

this unit and other equipment (especially,

1 Press DISP to cycle between the following:

8 W (impedance value).

high-current products such as power amps)

! Source name

! To prevent a short-circuit, overheating or mal-

must be wired separately. If they are not, an

! Source name and clock

function, be sure to follow the directions

accidental detachment may result in a fire or

below.

malfunction.

— Disconnect the negative terminal of the bat-

If an unwanted display appears

tery before installation.

This unit

— Secure the wiring with cable clamps or adhe-

Turn off the unwanted display using the proce-

sive tape. Wrap adhesive tape around wiring

dures listed below.

that comes into contact with metal parts to

protect the wiring.

1 Press M.C. to display the main menu.

— Place all cables away from moving parts,

such as the shift lever and seat rails.

2 Turn M.C. to change the menu option

— Place all cables away from hot places, such

and press to select SYSTEM.

as near the heater outlet.

— Do not connect the yellow cable to the battery

3 Turn M.C. to display DEMO OFF and press

by passing it through the hole to the engine

to select.

compartment.

— Cover any disconnected cable connectors

4 Turn M.C. to switch to YES.

with insulating tape.

— Do not shorten any cables.

5 Press M.C. to select.

— Never cut the insulation of the power cable of

this unit in order to share the power with

other devices. The current capacity of the

cable is limited.

— Use a fuse of the rating prescribed.

Section

02

Operating this unit

Installation

03

21

1 Power cord input

2 Rear output or subwoofer output

3 Antenna input

4 Fuse (10 A)

5 Wired remote input

Hard-wired remote control adapter can be

connected (sold separately).

8

En